Friedrich 2008, 2009 service manual To set the timer, To Activate Money Saver WY/WE models

To set the timer

NOTE: Set the HOUR CLOCK (Set Hour) before attempting to set timer functions.

You can set the Start Time and Stop Time a minimum of one hour apart, and a maximum of 23 hours apart.

11After setting the time, press the Set Hour button once (Start light on). Use the and buttons to select the time that the unit will START.

12After selecting the Start Time, press the Set Hour button once. (Stop Light on). Use the and buttons to select the time that the unit will STOP. After selecting the stopping time, press the Set Hour button once.

13Press the Timer On/Off button (light turns on) to activate the timer function. To deactivate this function, press the Timer On/ Off button once again (light turns off). Once the on and off times have been selected, they will remain in memory and cycle daily until changed.

NOTE: If the unit is unplugged or the power is interrupted, the HOUR must be reset or the Timer On/Off will not function when desired.

To Activate Money Saver (WY/WE models)

14Press the Money Saver button to activate the Money Saver feature. The light will indicate the Money Saver is in use.

MoneySaver® is a feature that cycles the fan with the compres sor so that the fan does not run all the time. This saves energy and improves dehumidification. MoneySaver® will also run to test the temperature if the off cycle is too long. Or you may prefer constant fan for more air movement. (To return to constant fan, touch the Mode button two more times).

Automatic component protection

Your unit is equipped with Automatic Component Protection.

To protect the compressor of the unit, there is a three minute delay if you turn the unit off or if power is interrupted. The fan will not be affected. Also, if you switch from Cool mode to Fan Only mode, and switch back to Cool mode, there is a three-minute delay before the compressor comes back on.

10