STEP 6 - Place the mounting pad.
Position the mounting pad so that the mounting holes are away from the house. Set the outdoor module on the mounting pad so that the module feet align with the mounting holes. Screw the outdoor module to the mounting pad with the 4 condenser pad installation washers and screws provided (Items #8 and #9 in the Accessories List).
STEP 6
STEP 7 – Connect the quick connector from the indoor line set outdoor module.
1.Open lock handle on line- set connector by pulling back and rotating toward indoor unit.
2.Grasp outer lock collar on
3.While holding outer lock collar rearward, push line- set connector body over base connector on outdoor unit half way and release outer lock collar.
4.Continue to push
5. Grasp lock handle and |
| 6. Install security screw | ||||||||
| ||||||||||
rotate to its closed posi- |
| (Item 13 in the Accessories | ||||||||
tion. |
| List) to prevent tampering | ||||||||
|
|
|
|
|
| with | ||||
|
|
|
|
|
| mechanism. | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
If you have excess connecting line, roll the line into a coil approximately 2 feet wide, secure with the provided wire ties and store between the outdoor module and the wall. DO NOT cut or kink the connecting line!
STEP 8 – Connect the electrical connector from the connecting line to outdoor module
1.Connect the black colored electrical connector from the connecting line into the mating connector on the outdoor module. The connectors will snap into place with a click. (The plug can be removed by pushing in the side tabs on the plug and pulling
the plug body down and out of the receptacle.) | Item #6 |
|
2. Install the electrical cord retention bracket (Item #6 in the Accessories List) using Item #10 two #8 x 3/4” screws (Item #10 in the Accessories List). The opening in the electrical
cord retention bracket should fit over the cord. Do not pinch the cord in the bracket.
3.Install the plastic cover (Item #2 in the Accessories List) as shown. There is one screw located on the lower right flange of the cover and one screw under the elec- trical connector access cover. Once secure, use enclosed screw (Item #10 in the Accessories List) to close the access door.
4.Install the quick connect cover as shown in figure 4. Once in place secure using
enclosed #8 x 3/4” screw located on the top flange of the quick connect cover. | Item #10 |
All Covers must be in place to operate unit.
SHOCK HAZARD exists without electrical access cover.
Cover cannot be installed without completing steps 8.1 through 8.4 properly.
1.
2.
3.
