Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3 Remote Control Signal Receiver
4 OPERATION Indicator Lamp (red)
5 TIMER Indicator Lamp (green)
6 SWING Indicator Lamp (orange)
(VERTICAL SWING)
7 SWING Indicator Lamp (orange)
(HORIZONTAL SWING)
●If the TIMER indicator lamp flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See page 16 Auto Restart).
8Intake Grille (Fig. 3)
9 Air Filter
0 UP/DOWN Air Direction Flaps
A RIGHT/LEFT Air Direction Louvers (behind UP/DOWN Air Direction Flaps)
B Drain Hose
Fig. 4 Remote Control Unit 
CSLEEP button
DMASTER CONTROL button
ESET TEMP./SET TIME buttons (
) F Signal Transmitter
G TIMER button
H FAN CONTROL button I START/STOP button
J AIR FLOW DIRECTION
VERTICAL SET button
K AIR FLOW DIRECTION
VERTICAL SWING button
L AIR FLOW DIRECTION
HORIZONTAL SET button
M AIR FLOW DIRECTION
HORIZONTAL SWING button N TIME ADJUST button
O ACL button
Rear side (Fig. 5)
PTEST RUN
●Touch the two metal contacts with a me- tallic object to send the signal to perform a test run.
●Perform a test run only when installing the air conditioner. If the signal to perform a test run is received during normal opera- tion, the air conditioner’s thermostat will malfunction.
●If the signal to perform a test run is re- ceived during normal operation, the unit will switch to the test operation mode and the indoor unit’s OPERATION and TIMER indicator lamps will flash simultaneously.
●To stop the test operation mode, press the START/STOP button to stop the air condi- tioner.
QRemote Control Unit Display (Fig. 6) R Transmit Indicator
S Clock Display
T Operating Mode Display U T imer Mode Display V Fan Speed Display
W Temperature Set Display X T imer Set Indicator
Y Temperature Set Indicator
En-4
4 | 1/21/10, 1:50 PM |
