Digital Control Panels
PM
Power
|
| Fan |
|
| Cool |
|
|
|
|
|
| ||
|
| Mode | Money Saver® |
| ||
|
| Speed |
|
| ||
|
|
|
|
| Fan Only |
|
|
|
|
|
| Clock |
|
|
| Timer | Set | Start Time |
| |
|
| On/Off | Hour | Stop Time | Temp/Hour | |
|
|
|
|
| ||
|
|
|
|
|
Figure 1: WS Model
Using the remote control
To start unit (See Figure 3, page 6)
1POWER - Press the Power button once. The unit will automatically start in the mode and fan speed it was last left on.
To set mode of operation
2COOL - Press the Cool button to automatically switch the operat- ing mode to COOL.
3FAN ONLY - Press the Fan Only button if you want to run the fan only.
4HEAT (WY/WE models only) - Press the Heat button to automatically switch the operating mode to HEAT.
5MoneySaver® - Press the Money Saver® button to activate the MoneySaver® feature. This feature cycles the fan with the compressor so that the fan does not run all the time.
To adjust temperature
PM
2 | 3 | 4 |
|
|
8 |
|
|
|
|
9 |
| Smart | Fan | Mode |
|
| Fan | Speed | |
14 |
| Money | Timer | Set |
| Saver | On/Off | Hour | |
13 |
|
|
|
|
10 | 11 | 12 |
|
|
Power1
Cool
Fan Only 6
Heat
7
Clock
Start Time 5
Stop Time
Temp/Hour
6
7COOLER - Press the Cooler button to lower the temperature setting.
To adjust fan speed
8FAN SPEED - Press the Fan Speed button to see the current setting. Press again to change the fan speed. F1 is the lowest setting (SLEEP / LOW), F2 is MEDIUM, F3 is HIGH, and SF is the SMART FAN setting.
To set the hour clock
9 SET HOUR CLOCK - Press the Set Hour. button once to see the |
current clock setting. Continue pressing the button until you |
arrive at the current time (Hour only). Minutes are not shown on |
Figure 2: WY/WE Model
Automatic component protection
Your unit is equipped with Automatic Component Protection.
To protect the compressor of the unit, there is a three minute delay if you turn the unit off or if power is interrupted. The fan will not be affected. Also, if you switch from Heat/Cool mode to Fan Only mode, and switch back to Heat/Cool mode, there is a
the display. Make sure that the A.M. / P.M. setting is correct. |
5