1.3 LOCATIONS OF CONTROLS
| Operation | Off | : Turns air conditioner off. | |
|
|
| ||
|
| Off | Hi Fan | : High speed fan operation without |
|
|
| cooling. | |
| Hi | Hi |
| |
|
|
| ||
| Fan O | Cool | Lo Fan | : Low speed fan operation without |
|
|
| ||
Lo | O | Lo |
| cooling. |
Fan | Cool |
|
| |
|
|
| Hi Cool | : Cooling with high speed fan |
|
|
|
| operation. |
|
| Mode | Lo Cool | : Cooling with low speed fan |
|
|
| ||
|
|
|
| operation. |
|
|
|
| |
| Thermostat |
|
| |
|
|
| This automatically controls the temperature of the | |
|
|
| indoor air. |
|
|
|
| Turn the knob so that the arrow points to the | |
|
|
| larger marks for greater cooling. Point the arrow to | |
|
|
| the smaller marks for more moderate cooling. | |
|
|
| (i.e. the higher the number, the greater the | |
Warmer | Cooler | cooling) |
| |
| Temperature |
| ||
|
|
| ||
|
|
|
|
|
CAUTION : After switching the air conditioner from Cool to Off or Fan, wait at least 3 minutes before switching it back to Cool.
1.4 SAFETY PRECAUTIONS
1.When servicing, set the ROTARY SWITCH to Off and unplug the power cord.
2.Observe the original lead dress.
If a short circuit is found, replace all parts which have been overheated or damaged by the short cir- cuit.
3.After servicing, make an insulation resistance test to prevent the customer from being exposed to shock hazards.
1.5 INSULATION RESISTANCE TEST
1.Unplug the power cord and connect a jumper between 2 pins (black and white).
2.The grounding conductor (green or green and yel- low) is to be open.
3.Measure the resistance value with an ohm meter between the jumpered lead and each exposed metallic part on the equipment at all position [except Off] of the ROTARY SWITCH.
4.The value should be over 1 MΩ .
