Water Level
There is no need to select a water level. The
washer automatically adjusts the water level to the
type and size of wash load.
Cycle Options
To select Heavy Soil/Stain, Auto Temp, Extra Spin
and Extra Rinse, press OPTIONS until flashing
light indicates desired option. Then press SELECT
to add that option to the cycle. To delete an indi-
cated option, press SELECT.
Heavy Soil / Stain
Use this option to add approximately 6 minutes of
wash time to very soiled or stained loads.
Auto Temp
The temperature of hot, warm and cold wash wa-
ter can be affected by the water heater setting and
seasonally low ground water temperatures in some
geographic areas. Since detergents work best in
wash water at a minimum of 65° F, select AUTO
TEMP to regulate the temperature of hot wash to
approximately 150° F, warm wash to approximately
90° F and cold wash to approximately 70° F. Rinse
water temperatures are not regulated.
Extra Rinse
Use this option when additional rinsing is desired
to remove excess dirt and detergent. It is recom-
mended for heavily soiled loads or if household
members have sensitive skin. Extra Rinse occurs
before the liquid fabric softner is dispensed.
Extra Spin
Use this option for several additional minutes of
spin at the selected spin speed. This will increase
water extraction and decrease drying time.
Washer Features
Add A Garment
The Add A Garment light will be lit during all wash
cycles as a reminder that a forgotten item can be
added to the load.
Control Lock
To prevent accidental operation of the washer or
alteration of the cycle settings, press and hold the
lock symbol until you hear 3 beeps and “LOC” is
displayed. To cancel, press and hold the lock sym-
bol until “LOC” is no longer displayed.
Signal
A signal will sound at the end of the cycle. Re-
peatedly press the signal symbol to select one of
three volume levels or turn off the signal. The se-
lection will be programmed until you change it.
Display
The following will be displayed during the cycle:
•Estimated Remaining Cycle Time
•Door Lock
•Cycle Status (WASH, RINSE, FINAL
SPIN).
•Signal volume selected
•“LOC” will be displayed briefly when lock
symbol is pressed.
Error Codes
If the washer stops and the F 01,F 03, F 04 or
F 05 error code is flashing in the display, press
STOP/CANCEL, select a cycle and press
START. If the error code appears again, please
contact service for assistance.
•F 01 - There may be an internal problem
with the wash system.
•F 02 - There may be a water temperature
problem. Be sure hot and cold wa
ter hoses are properly connected
before calling service.
•F 03 - Be sure the water is turned on be
fore calling service. There may be a
problem with the pump or pressure
switch.
•F 04 - The washer may have run too long
or there may be a problem with the
motor control.
•F 05 - There may be a problem with the
keypad.
PN 134305500A (0311)Page 3