ELECTRICAL CONNECTIONS

FOR A 3-WIRE SYSTEM

NON-CANADIAN ELECTRIC Laundry Center

ELECTRICAL CONNECTIONS

FOR A 4-WIRE SYSTEM

NON-CANADIAN ELECTRIC Laundry Center

1. Remove the screw securing the terminal block access cover to the rear panel and remove cover.

2. Install a U.L. approved strain relief connector in the entry hole on the back panel.

3.Insert a NEMA 10-30 Type SRDT,

U.L. approved power cord through the strain relief.

4.Attach the power cord neutral (central wire) conductor to the silver colored center terminal on the terminal block. Tighten the screw securely.

GREEN GROUND SCREW

SILVER TERMINAL

 

1. Remove the screw securing the terminal block access cover to the rear panel and remove cover.

2. Install a U.L. approved strain relief connector in the entry hole on the back panel.

3.Remove the neutral ground wire from the green ground screw located above the termial block.

NEUTRAL GROUND WIRE

NEUTRAL GROUND WIRE

5.Attach the remaining two power cord outer conductors to the outer brass colored terminals on the terminal block. Tighten both screws securely.

6.Tighten the screws securing the cord restraint against the power cord.

7.Reinstall the terminal access cover.

4.Insert a NEMA 14-30 Type ST or SRDT, U.L. approved power cord through the strain relief.

5.Attach the green power cord ground wire to the cabinet with the green ground screw.

6.Attach the white (neutral) wire from the power cord and the neutral ground wire from the appliance harness to the silver colored center terminal on the terminal block. Tighten the screw securely.

7.Attach the red and black wires from the power cord to the outer brass-colored terminals on the terminal block. Tighten both screws securely.

8.Tighten the screws securing the cord restraint firmly against the power cord.

9.Reinstall the terminal block access cover.

9

Page 9
Image 9
Frigidaire 134897500B installation instructions Electrical Connections For a 3-WIRE System