Grounding requirements - Gas dryer (USA and Canada)
1.The dryer is equipped with a
2.The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. If in doubt, call a licensed electrician.
DO NOT cut or remove ground prong from the plug.
Grounding type wall receptacle
Do not, under
any circumstances, cut, remove,
or bypass the grounding prong.
Power cord with
Gas connection
1.Remove the shipping cap from gas pipe at the rear of the dryer.
DO NOT connect the dryer to L.P. gas service without converting the gas valve. An L.P. conversion kit must be installed by a qualified gas technician.
2.Connect a 1/2 inch (1.27 cm) I.D.
Manual | Flare | GAS FLOW | |||
Shutoff | Flare | ||||
Union | Union | ||||
| Valve | ||||
|
|
| |||
|
|
|
|
| |
|
|
|
|
|
Closed
Nipple | Flexible | Inlet Pipe on |
Open | Connector | Back of Dryer |
All connections must be
The supply line must be equipped with an ap- proved manual shutoff valve. This valve should be located in the same room as the dryer and should be in a location that allows ease of opening and closing. Do not block access to the gas shutoff valve.
3.Open the shutoff valve in the gas supply line to allow gas to flow through the pipe. Wait a few minutes for gas to move through the gas line.
to dryer
from | gas | supply |
| ||
|
|
Shutoff Valve -
Open position
4.Check for gas system leaks with a manometer. If a manometer is not available, test all connections by brushing on a soapy water solution.
- EXPLOSION HAZARD - NEVER test for gas leaks with an open flame.
10