Electrical connection (non-Canada) - 4 wire cord
4-wire receptacle
(NEMA type
- ELECTRICAL SHOCK HAZARD - Failure to disconnect power source before servicing could result in personal injury or even death.
|
| Neutral |
30 AMP | Ground | (WHITE wire) |
| ||
(GREEN wire) |
| |
NEMA |
| |
|
|
1.Turn off power supply to outlet.
2.Remove the screw securing the terminal block access cover in the lower corner on the back of the dryer.
3.Install a
4.Thread an UNPLUGGED,
5.Disconnect the internal (BLACK) dryer harness ground wire from the (GREEN) ground screw next to the terminal block.
6.Attach the ground (GREEN) power cord wire to the cabinet with the ground (GREEN) screw. Tighten the screw securely.
7.Move the internal dryer harness ground (BLACK) wire to the terminal block and attach it along with the neutral (WHITE) power cord wire conductor to the center, SILVER colored terminal on the terminal block. Tighten the screw securely.
8.Attach the RED and BLACK power cord conductors to the outer, BRASS colored terminals on the terminal block. Tighten both screws securely.
Access cover
screw
Terminal
block
Line 2
(BRASS terminal)
Neutral
(SILVER terminal)
Line 1
(BRASS terminal)
Internal ground (GREEN screw)
Install
strain relief here
Terminal screw
recovery slot
If a terminal screw falls during cord installation, it can be retrieved in the terminal screw recovery slot below the access panel.
- ELECTRICAL SHOCK HAZARD - Do not make a sharp bend or crimp wiring/conductor at connections.
9.Follow manufacturer’s guidelines for firmly securing the strain relief and power cord.
10.Reinstall the terminal block cover.
Move internal ground (BLACK)
wire to neutral (SILVER)
terminal for
GREEN
ground screw
GREEN
ground wire
BLACK or
RED power wire
Neutral terminal
WHITE
neutral wire
BLACK or RED
power wire
12
