Frigidaire 137153700B Front Console Dimensions, Rear Console Dimensions, Electrical installation

Front Console Dimensions

electrical supply on rear of unit, power cord length on gas unit approximately 59” (150 cm)

under-counter

installation height

36”

(91.5 cm)

34 5/8”

(87.9 cm)

		to center of
			rear vent				center line
				13 1/2”				height for
			(34.4 cm)					rear vent
1”									3 3/4”
									(9.5 cm)
(2.5 cm)
					gas supply pipe on
	2 9/16”					rear of gas unit
	(6.5 cm)
						47 1/2” (120.7 cm)
					to clear open door

	4 3/8”
	(11 cm)
optional vent	3 3/4”
knockout	(9.5 cm)
27” (68.6 cm)

Rear Console Dimensions

	electrical supply on rear of unit,
											43 5/8”
	power cord length on gas unit
											(111 cm)
	approximately 59” (150 cm)
										36”
										(91.5 cm)
				to center of
					rear vent				center line
					13 1/2”				height for
				(34.4 cm)					rear vent
	1”								3 3/4”
									(9.5 cm)
(2.5 cm)
							gas supply pipe on
			2 9/16”					rear of gas unit
		(6.5 cm)
						47 1/2” (120.7 cm)
						to clear open door

	4 3/8”
	(11 cm)
optional vent	3 3/4”
knockout	(9.5 cm)
27” (68.6 cm)

Electrical installation

The following are specific requirements for proper and safe electrical installation of your dryer. Failure to follow these instructions can create electrical shock and/or a fire hazard.

- ELECTRICAL SHOCK HAZARD -

•This appliance MUST be properly grounded. Electrical shock can result if the dryer is not properly grounded. Fol- low the instructions in this manual for proper grounding.

•Do not use an extension cord with this dryer. Some ex- tension cords are not designed to withstand the amounts of electrical current this dryer utilizes and can melt, creat- ing electrical shock and/or fire hazard. Locate the dryer within reach of the receptacle for the length power cord to be purchased, allowing some slack in the cord. Refer to the pre-installation requirements in this manual for the proper power cord to be purchased.

- ELECTRICAL SHOCK HAZARD -

•A U.L.-approved strain relief must be installed onto pow- er cord. If the strain relief is not attached, the cord can be pulled out of the dryer and can be cut by any movement of the cord, resulting in electrical shock.

•Do not use an aluminum wired receptacle with a copper wired power cord and plug (or vice versa). A chemical reaction occurs between copper and aluminum and can cause electrical shorts. The proper wiring and receptacle is a copper wired power cord with a copper wired recep- tacle.

Dryers operating on 208 volt power supply will have longer drying times than dryers operating on 240 volt power supply.

8