installation instructions
Connecting drain and electrical
1Snap one end of the drain hose hanger (shipped in washer drum) onto the drain hose. Continue wrapping it around the hanger and snap it in place.
2Place the hook end of the drain hose in the drain opening. Secure the drain hose with the cable tie (provided in the enclosure package) to the standpipe, inlet hose, laundry tub, etc. so the hose does not pull out from the force of the water.
IMPORTANT
Check to ensure the power is off at a circuit breaker/ fuse box before plugging the power cord into an outlet.
3Plug the power cord into a grounded outlet.
Grounding type wall receptacle
Do not, under | CABLE TIE |
any circumstances, |
|
cut, remove, |
|
or bypass the |
|
grounding prong. |
|
Power cord with
4Turn on the power at a circuit breaker/fuse box.
5Carefully slide the washer to its final position.
Recheck for level and rock corners for stability. Remove and discard door tape.
6Read the Use & Care Guide provided with the washer. It contains valuable and helpful information that will save you time and money.
7If you have any questions during initial operation, please review the “Service Prevention Checklist” in your Use & Care Guide before calling for service.
8Place these instructions in a location near the washer for future reference.
NOTE
A wiring diagram and technical data sheet are located under the washer top panel, on top of the detergent dispenser housing.
10
