Frigidaire 2020213A0362 manual Alternate Window Jamb Applications, Install safety bracket

16.Slide inner window sash firmly against side of the cabinet. Make sure not to peel the seal strips from the window track and cabinet side channels. If the panel frame does not fit snugly to the inner window sash, secure the panel frame to the sash with #8x3/4-inch screws, or #8-32x3/4-inch self- threading screws. Use the partially plugged holes in the panel frame. Drill 1/8-inch pilot holes for the screws.

17.Hook the safety bracket over the base of the unit and fasten it to the front of the platform assembly. Use a #8-32x3/4-inchself-threading screw.

NOTE: The bracket prevents movement of the air conditioner (either in or out) after completing the installation.

18.Stuff the foam seal strip/sash seal between the vertical sash and the window glass, as shown right.

19.Use the window locking bracket to lock the inner window sash to the base of the outer window sash. Use one #8x3/4-inch screw, or #8-32x3/4- inch self-threading screw. (Drill 1/8-inch pilot hole).

20.To replace the front

First reconnect the coupler plugs, make the exhaust control positioned through the front in the proper location. Gently push the front into position on the cabinet. It should click into place. Then replace the retaining screws that holds the panel in place.

Do not push or pull the front panel louvers.

Slide inner window sash firmly against Cabinet.

Install safety bracket

Safety bracket

Sash seal

Window locking bracket

Alternate Window Jamb

Applications

To install in windows having no flanges or wood stops on the top and side jambs, the channels and panel frame must fit against a mating flange (or 1/16-inch max. thick angle) attached to the window jambs. Figure A shows this angle installed. Figures B & C show alternate treatments. On the sash side of the opening, the leading corner of the inner sash becomes the flange. You can purchase the angle strip locally.

Flush

Room Room Room

A	B	C
Add angle to	Add wood	Add 16- or 18-
wood stop	as shown	gauge angle

7