Frigidaire 2020213A0362 manual Installing Unit in a Sliding Window

3.Choose the proper window location.

Choose a window that allows the cooled air to flow freely and directly into room(s) you wish to cool. Remember, it is difficult to move air around corners. Also, choose a window that is within 6 feet of an electrical outlet. (See Meeting Electrical Requirements/Receptacle wiring needs.) Do not

use an extension cord.

6 foot

power cord

reach

Installing Unit in a Sliding Window

1.Attach support brace to platform as shown. Use adjustment bolt and hex flange nut to complete

assembly. Choose slot and adjustment bolt hole	Platform Assembly
locations that will create a 45 degree angle between
platform and support brace. Try assembly in the
window to determine if platform will rest properly, and
allow proper slope (3/16-inch lower on outside).
NOTE: If you are planning to use a siding-	1/4" (6mm) HEX FLANGE NUT
protection board (see Step 5) on the outside of your
house, hold board in place when testing assembly in
window.

2.Measure, and lightly mark a line 8-11/16 inches from window jamb.

NOTE: If any sash stop protrudes more than 1 inch from the side window jambs, the 8-11/16-inch measurement must be increased accordingly.

Screen and storm window frames may also require adjustments to the measurement.

3.Center platform assembly on the line with inside platform tab pressed against inside edge of window track. Using the holes in the platform as a guide, mark and drill two 9/64-inch diameter holes. Drill holes in either track or stool.

CAUTION

Property Damage Hazard-Failure to adhere to the following precaution could result in damage to window or air conditioner.

Be sure wood stool or window track is securely attached to the building construction. Use longer screws in sub-framing if necessary.

(continued)

8 11/16 inches

Alternate screw location (depending on the stool depth)

Platform tab

Window track Window seal

Center platform assembly on the line with platform tab pressed against window track

4