Automatic Ice & Water Dispenser (Continued)
Automatic Ice & Water Dispenser Operating Instructions
1 2 3 4
56
Features may vary according to model.
Crushed | Press the Crushed Touch Pad | 1 | to get crushed ice. A red indicator will appear above the Touch Pad. |
| Press glass against ICE dispensing paddle 5 as far up as possible to catch all ice. | ||
|
|
| |
Cubed | Press the Cubed Touch Pad | 2 to get cubed ice. A red indicator will appear above the Touch Pad. | |
| Press glass against ICE dispensing paddle 5 as far up as possible to catch all ice. | ||
|
|
|
|
Light On | Press the Light On Touch Pad | 3 | to turn on dispenser light. A red indicator will appear above the |
| Touch Pad. |
|
|
|
|
|
|
Light Off | Press the Light Off Touch Pad | 4 | to turn off dispenser light. A red indicator will appear above the |
| Touch Pad. |
|
|
|
| ||
Water | To operate the water dispenser, press a glass against the WATER dispensing paddle 6 . To stop | ||
| dispensing water, pull the glass away from the dispensing paddle 6 . Dispensed water is not cold. | ||
| For colder water, add crushed ice or cubes before dispensing water. A drip tray located at the base | ||
| of the dispenser catches small spills and allows them to evaporate. This drip tray is removable and | ||
| dishwasher safe. Do not pour water and excess ice in this area because there is no drain. | ||
|
|
|
|
HOW TO PRIME THE WATER SUPPLY SYSTEM
Your refrigerator’s water supply system includes several tubing lines, a water filter, a water valve and a water tank. To ensure that your water dispenser works properly, this system must be completely filled with water when your refrigerator is first connected to the household water supply line and whenever you replace the water filter.
CAUTION
For proper dispenser operation, recommended water supply pressure should fall between 30 psi and 100 psi. Excessive pressure may cause water filter to malfunction.
TO PRIME THE WATER SUPPLY SYSTEM:
•Begin filling the tank by pressing and holding a drinking glass against the water dispenser paddle.
•Keep the glass in this position until water comes out of the dispenser. There will be noticeable spurts and sputters as the system pushes air out through the system and dispenser nozzle. This is normal. This may take about 1½ minutes.
•Continue dispensing water for about 3 minutes to flush the system of any air and impurities. Empty glass as needed.
NOTE
The water dispenser has a
HOW THE ICE MAKER WORKS
CAUTION
Chemicals from a malfunctioning softener can damage the ice maker. If the ice maker is connected to soft water, ensure that the softener is maintained and working properly.
IMPORTANT
Your ice maker is shipped from the factory with the wire signal arm in the ON position (side mounted) or with the switch turned ON (rear mounted). To ensure proper function of your ice maker, hook up water supply immediately or turn ice maker OFF by lifting the wire signal arm until it clicks and locks in the UP position (side mounted) or turn the On/ Off switch to the Off (0) position. If the ice maker is not turned off and the water supply is not connected, the water valve will make a loud chattering noise.
10
