Frigidaire 242292000 Level Refrigerator & Adjust Doors, Leveling Freezer Drawer if necessary

INSTALLATION

Leveling Freezer Drawer (if necessary)

1Check gasket seal around top, bottom, and sides of freezer drawer.

2If gasket is not sealed, open drawer and slightly loosen four drawer screws (two on each side) to allow drawer to rotate.

3Close drawer and recheck the seal on the gasket

(A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer.

To level the cabinet using the front rollers (select models):

1Slightly open freezer drawer. Lift the toe grille and gently pull forward (see illustration).

2You can raise or lower each door. Use a ⅜ inch socket wrench to turn the adjustment screws (one per side).

Toe Grille Must

Fit in Slot on

Anti-tip Bracket

Remove Hex

Head Drawer

Screw

Do Not Remove

Other Screws

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Do Not Remove

Other Screws

Remove Hex

Head Drawer

Screw

Screw/Washer

Assembly

(3) Retaining Clips

To raise: turn adjustment screw clockwise.

4Tighten four drawer screws.

5 Recheck gasket seal.

	Grab Drawer
	At Center
Push Against	From Both Sides
	Then
Freezer Drawer	Pull Drawer Out

A B

Level Refrigerator & Adjust Doors

(if necessary)

Guidelines for final positioning of your refrigerator:

•All four corners of the cabinet must rest firmly on the floor.

•The sides should tilt ¼ inch (6 mm) from front to back (to ensure that doors close and seal properly).

•Doors should align with each other and be level.

Most of these conditions can be met by raising or lowering the adjustable front rollers.

To lower: turn adjustment screw counterclockwise.

3Ensure both doors are bind-free with their seals touching the cabinet on all four sides and that cabinet is stable.

4After unit is leveled, lower anti-tip leg until it contacts the floor.

Door Door

Raise

Anti-tip

Leg

Lower

5Install the toe grille by fitting into place.

6