Changing Cooktop and/or Oven Lights
(if equipped)
Be sure the range is unplugged and all parts are COOL before replacing the surface or oven lights. Wear a
To Change the Oven Light (some manual clean models)
On some models, the oven light automatically turns on when the door is opened. Some models have a switch located on the control panel to turn on the light. The oven light is located at the rear of the oven.
To replace the oven light:
1.Turn electrical power off at the main source or unplug the range.
2.Replace bulb with a new 40 watt appliance bulb.
3.Turn power back on again at the main source (or plug the range back in).
4.The clock(if equipped) will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Owner's Guide.
To Change the Cooktop Light (some models)
1.Turn power off at the main source or unplug the range.
2.Remove Phillips® Head screws (2) that secure the light cover and then lift the light cover off.
3.Remove bulb by rolling back and up. Install the new bulb by sliding down and rolling forward into place.
4.
Avoid Service Checklist
Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.
OCCURRENCE | POSSIBLE CAUSE/SOLUTION |
Range is not level. | Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust |
| leveling legs at base of range until the rack is level. When range is level, cooktop may |
| appear out of alignment if countertop is not level. |
|
|
| Weak, unstable floor. Be sure floor is level and can adequately support range. Contact |
| a carpenter to correct sagging or sloping floor. |
|
|
| Kitchen cabinet misalignment may make range appear to be unlevel. Be sure cabinets |
| are square and have sufficient room for range clearance. |
Cannot move appliance easily. Appliance Cabinets not square or are built in too tight. Contact a cabinet maker to correct the
must be accessible for service. | problem. | |
|
|
|
| Contact builder or installer to make appliance accessible. | |
|
|
|
| Carpeting interferes with range. Provide sufficient space so range can be lifted over | |
| carpet. | |
|
| |
| Gas line is |
|
| connector installed. | |
|
|
|
Surface burners do not light. | Surface Control knob has not been completely turned to LITE. Push in and turn the | |
| Surface Control knob to LITE until burner ignites and then turn control knob to desired | |
| flame size. | |
|
|
|
| Burner ports are clogged. With the burner off, use a | |
| ports. See "Surface Burners" in the cleaning chart under General Cleaning for | |
| additional cleaning instructions. | |
|
|
|
| Range power cord is disconnected from outlet (Electric Ignition Models only). Be sure | |
| cord is securely plugged into the outlet. | |
|
|
|
| Electrical power outage (electric ignition models only). Burners can be lit manually. See | |
| Setting Surface Controls in this Owner's Guide. | |
14
