Cleaning the cooktop and surface burners
CAUTION
To avoid possible burns use care when cleaning the cooktop. DONOT attempt to clean the cooktop whenever the cooktop or burner heads are still hot.
To avoid possible burns DO NOT attempt any of the cleaning instructions provided below before turning OFF all of the surface burners and allow them to cool.
The cooktop and surface burners are designed to make cleaning easier. Since cooktop surface burners are sealed, cleanups are easy when spillovers are cleaned up immediately. Routinely clean the cooktop. Wipe with a clean, damp cloth and wipe dry to avoid scratches. The contoured well areas and burner drip pans (some models) should be frequently cleaned also.
Keeping the burner head ports and slots clean will prevent improper ignition and an uneven flame. Refer to the following sections for further instructions.
To clean the burner head ignition ports
Each burner head has a small ignition port located as illustrated. Should you experience ignition problems it may be that this port hole is partially blocked with soil. With the burner head in place, use a small wire gauge needle or the end of a paper clip to clear the ignition port.
To clean the surface burner heads
For proper gas flow it may be necessary to clean the burner head and slots. To clean, first use a clean DAMP cloth to soak up any spills. Remove any food from between the burner slots using a small
To clean the recessed and contoured well areas of the cooktop
If a spill occurs on or in the recessed or contoured areas, blot up spill with an absorbent cloth. Rinse with a clean, damp cloth and wipe dry.
To clean the surface burner grates, caps & burner drip pans (some models)
Use a
CARE & CLEANING
ignition port
slots
orifice port
Fig. 1 - Cooktop burner head
IMPORTANT
The surface burner heads are secured to the cooktop and must be cleaned in place on the cooktop.
For proper flow of gas and ignition of the burner — DO
NOT allow spills, food, cleaning agents or any other material to enter the gas orifice holder opening. Always keep the surface burner cap and surface burner head in place whenever a surface burner is in use.
Replacing the oven light
The light bulb is located at the rear of the oven and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use.
To replace the oven light bulb:
1.Turn electrical power off at the main source or unplug the range.
2.Press wire holder to one side to release the glass shield that covers the light bulb.
3.Replace bulb with a new 40 watt appliance bulb.
4.Replace glass shield over bulb and snap wire holder back into place.
5.Turn power back on again at the main source (or plug the appliance back in).
6.The clock will then need to be reset. To reset, see Setting the clock in this Use & Care Guide.
CAUTION
Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a
23
