Important Safety Instructions
Grounding instructions
For personal safety, the cooktop must be properly grounded. For maximum safety, the power cord must be plugged into an electrical outlet that is correctly polarized and properly grounded.
DO NOT operate the cooktop using a
See the installation instructions packaged with this cooktop for complete installation and grounding instructions.
WARNING
This appliance is equipped with a
Grounding
type wall Do not, under any
receptacle circumstances, cut, remove, or bypass the grounding prong.
Power supply cord with 3-prong grounding plug
Oven Ignition
When you turn the oven on, the glow bar igniter begins to heat. When the lighter is hot enough, in less than 1 minute, the gas flows into the burner and is ignited.
The igniter glows bright orange when hot. It cycles on and off with the thermostat and will glow whenever the burner is on.
WARNING
Do not attempt to light the oven burners during a power failure. The oven burner valves will not open up and will prevent the gas from flowing through the burner valves to the burners. In the event of a power failure, turn the Temperature Control knob to OFF. When power resumes, turn the Temperature Control knob back to desired temperature.
Conversion to liquefied petroleum gas (or L.P. gas)
This natural gas range is designed to allow for conversion to Liquefied Petroleum (L.P.) Gas.
If L.P. conversion is needed, contact the service center for assistance. The L.P. Conversion Kit is provided with this cooktop and is located in the literature envelope.
Before installing the kit be sure to follow the L.P. Installation Instructions carefully.
WARNING
Personal injury or death from electrical shock may occur if the range is not installed by a qualified installer or electrician.
WARNING
Avoid fire hazard or electrical shock. DO NOT use an adapter plug, an extension cord, or remove grounding prong from electrical power cord. Failure to follow this warning can cause serious injury, fire or death.
CAUTION
Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by an authorized Service Center.
5