Frigidaire 318203858 warranty Setting Warm & Serve Drawer Control If Equipped

Setting Warm & Serve Drawer Control (If Equipped)

Arranging Warm & Serve Drawer Rack Positions

The rack can be used in 2 ways:

•In the upright position to allow low profile food items to be placed both under and on top of the rack (for example, rolls or biscuits on top of the rack and a casserole dish underneath).

•In the downward position to allow you to place light weight food items and empty dishware (for example, rolls or pastries and dinner plates) on the rack.

Set the Warm & Serve Drawer Rack in either position as shown below (Figure 1).

Warm & Serve Drawer Rack in upward position

Operating the Warm & Serve Drawer
The purpose of the Warm & Serve Drawer is to keep hot cooked foods at serving temperature.
Always start with hot food. It is not recommended to heat cold food in the Warm & Serve
Drawer. All food placed in the Warm & Serve Drawer should be covered with a lid or aluminum
foil to maintain quality. Do not use plastic wrap to cover food. Plastic may melt onto the
drawer and be very difficult to clean. Use only utensils and cookware recommended for
oven use in the Warm & Serve Drawer.									Serve
								Warm &
	Always use potholders or oven mitts when removing food from the Warm &							Drawer	Rack in
							Figure 1	downward
Serve Drawer as cookware and plates will be hot and you can be burned.								position
Warm & Serve Drawer Temperature Selection						Warm & Serve Drawer
Recommended Warm & Serve Drawer settings table is shown in Figure 2. If a						recommended Food Settings Table
particular food is not listed, start with the MED setting. If more crispness is desired,						Food Item		Setting
remove the lid or aluminum foil from the food. Most foods can be kept at serving						Bacon			HI
temperatures on the MED setting. When a combination of foods are to be kept warm						Hamburger Patties			HI
(for instance, meat with 2 vegetables and rolls), use the HI setting. To avoid heat loss,						Poultry			HI
do not open the Warm & Serve Drawer while in use.						Pork Chops			HI
To Set the Warm & Serve Drawer Controls:						Fried Foods			HI
						Pizza			HI
The control and indicator lights for the Warm & Serve Drawer features are located on						Gravies		MED
the control panel. The temperatures are approximate, and are designated by HI (high),						Casseroles		MED
MED (medium) and LO (low).						Eggs		MED
1. Touch the	(see Figure 6) pad at the Warm & Serve Drawer control position. The					Roasts (Beef, Pork, Lamb) MED
						Vegetables		MED
Warm & Serve Drawer indicator light will flash. Note: If no further pads are touched						Biscuits		MED
within 25 seconds the request to power the Warm & Serve Drawer ON will clear.						Rolls, hard		MED
2. Set the desired power level. Touch				once to turn ON the power level for HI		Pastries		MED
						Rolls (soft)		LO
(see Figure 3) or		to turn ON the power level for LO (see Figure 5). The Warm				Empty Dinner Plates		LO
							Figure 2
& Serve Drawer indicator light located beside the					pad will turn ON steady.
3. Each touch of the		or	pads will decrease or increase through 5 power levels from HI (see

Figure 3) to MED (see Figure 4) to LO (see Figure 5). Note: For best results, preheat the Warm & Serve Drawer before adding the food . An empty drawer will preheat in approximately 15 minutes.

4. When the food is ready for removal, touch the pad once to turn the Warm & Serve Drawer OFF. The Warm & Serve Drawer indicator light will turn OFF.

Note: The Warm & Serve Drawer is inoperable during the self-clean cycle.

Note: The Warm & Serve drawer is equipped with a latch
which may require extra force when opening and closing
	Figure 3	Figure 4	Figure 5	Figure 6
the drawer.
	11