Setting OVEN controls
Setting MINUTE Timer
The TIMER ON.OFF pad controls the Minute Timer feature. The Minute Timer serves as an extra timer in the kitchen that will beep when the set time has run out. It does not start or stop cooking. The Minute Timer feature can be used during any of the other oven control functions. Refer to “Minimum and Maximum Control Pad Settings” for time amount settings.
To set the Minute Timer (example for 5 minutes)
1.Press TIMER ON.OFF.
2.Use the number pads to set the desired time in the display; press 5.
3.Press START. The time will begin to count down with “5:00” in the display.
Note: If START is not pressed the timer will return to the time of day after 25 seconds.
4.When the set time has run out, “End” will show in the display. The clock will sound with 3 beeps every 5 seconds until TIMER ON.OFF is pressed.
To cancel the Minute Timer before the set time has run out
1.Press TIMER ON.OFF. The display will return to the time of day.
Setting + 1 Min Feature
The + 1 MIN pad is used to set the Add 1 Minute feature. When the + 1 MIN pad is pressed, 1 minute is added to the Minute Timer feature if this feature is already active. If the Minute Timer feature is not active and the + 1 MIN pad is pressed, the Minute Timer feature will become active and will begin counting down from 1 minute.
Setting Lockout Feature
The 
pad controls the Lockout feature. The Lockout feature automatically locks the oven doors, the control panel and the cooktop. It does not disable the Minute Timer or the interior oven lights.
To activate the Lockout feature
1.Press and hold 
for 3 seconds.
2.After 3 seconds “Loc” and “Control” will appear, a beep will sound, “UPPER”, “LOWER” and “DOOR” will flash in the display. Once the oven door is locked the “DOOR” will stop flashing and remain on along with the “Loc”, “Control” and the 
icon will appear.
To reactivate normal operation:
1.Press and hold 
for 3 seconds. A beep will sound. The “UPPER”, “LOWER” and “DOOR” will flash in the display until the oven door has completely unlocked and the 
icon will disappear.
2.The unit is again fully operational.
NOTE
The surface elements cannot be activated when the Lockout feature is active (see the section: The electronic surface element control (ESEC)).
18
