Frigidaire FFHS2313LM Door Opening, Guidelines for final positioning of your refrigerator

INSTALLATION

Door Opening

NOTE

The refrigerator doors are designed to shut by themselves within a 20 degree opening.

Your refrigerator should be positioned to allow easy access to a counter or table when removing food. For best use of drawers and freezer baskets, the refrigerator should be in a position where both the refrigerator and freezer doors can be fully opened.

Guidelines for final positioning of your refrigerator:

•All four corners of the cabinet must rest firmly on the floor.

•The cabinet should be level at the front and rear.

•The sides should tilt ¼ inch (6 mm) from front to back (to ensure that doors close and seal properly).

•Doors should align with each other and be level.

All of these conditions can be met by raising or lowering the adjustable front rollers.

To level the cabinet using the front rollers:

1Open both doors and remove the toe grille (see “Toe Grille Installation and Removal” in the “Installation” section).

2Close the doors and use a flat-blade screwdriver or 3/8 inch socket wrench to raise or lower the front rollers.

3Ensure both doors are bind-free with their seals touching the cabinet on all four sides.

Raise

To level the doors using the adjustable lower hinge:

NOTE

Some models will not have a set screw. For those models follow steps 2 through 4.

1Before leveling either door, remove set screw that locks door height into position. (The door cannot be adjusted without set screw removed).

2If the refrigerator door is lower than the freezer door, raise the refrigerator door by turning the adjustment screw clockwise using a 7/16 inch wrench. (See illustration.)

3If the freezer door is lower than the refrigerator door, raise the freezer door by turning the adjustment screw clockwise using a 7/16 inch wrench. (See illustration.)

Door Door

Raise	Raise
Door	Door

4After leveling, verify door stop contacts lower hinge and top of door does not contact upper hinge through full movement of door (from fully closed to fully open).

5Reinstall set screw, locking the door height.

Open Door
Door Stop
Flange	Hinge
	Flange
	Set Screw
	(some models)
7/16" Wrench	Hinge
and
3/32" Hex Key
(some models)

6Replace the toe grille by fitting it into place (see “Toe Grille Installation and Removal” in the “Installation” section).

6