Reversing the door swing
The glass door can be opened from left to right and vice versa. Should you desire to change the opening direction, please follow these instructions.
NOTE
All parts removed must be saved to do the reinstallation of the door.
1.Remove top cap. Remove the three screws that hold the upper hinge (right side) to the top of the cabinet. See Fig. 1.
2.Carefully remove top hinge (See Fig. 1.), then lift the door up off of bottom hinge and place it on a padded surface to prevent scratching it. See Fig. 2.
3.Remove the three button plugs from the upper left corner of the cabinet and transfer them to the holes on the opposite side. Be sure to press the button plugs firmly into the holes. See Fig. 1.
4.Remove three screws that hold the bottom hinge to lower end of cabinet. Remove the three button plugs from lower LH corner and transfer to holes where bottom hinge was just removed. See Fig. 3.
5.Unscrew pins from both hinges and transfer to threaded hole on opposite side. See Fig. 4.
6.On bottom edge of door, transfer door stop bracket and bushing to holes on opposite side. See Fig. 6.
7.On top edge of door, transfer the button plugs and bushing to hole on opposite side. See Fig. 7.
8.Place bottom LH corner of door onto lower hinge, then install top hinge to cabinet. Make sure door is level and it seals properly against cabinet, then securely fasten three screws. See Fig. 7. Snap top cap back onto hinge.
Button plugs
Top cap
Screws
Hinge
Bushing
Fig. 1
INSTALLATION
Fig. 2
Button plugs |
|
|
Fig. 3 | Screws | Hinge |
| Move pin to |
| opposite hole |
| (upper and |
Fig. 4 | lower hinges) |
| |
|
|
Screws
Fig. 5
Button plugs 
5
