CHANGING THE FILTER
Locating the Filters
Your refrigerator is equipped with water filtering system. The water filter system filters all dispensed drinking water, as well as the water used to produce ice.
Water Filter
The water filter is located at the top right side of the fresh food compartment.
Replacing the Water Filter
In general, you should change the water filter every six months to ensure the highest possible water quality. Water Filter Status on the user interface prompts you to replace the filter after a standard amount of water (200 gallons/757 liters for PureSource UltraTM) has flowed through the system.
If your refrigerator has not been used for a period of time (during moving for example), change the filter before reinstalling the refrigerator.
Ordering Replacement Filters
To order your replacement filters, please visit our online store at www.frigidaire.com/store, by calling
Here is the product number to request when ordering:
PureSource UltraTM Water Filter
Part #ULTRAWF
NOTE
When ordering your replacement filter, please reorder the same filter type that is currently in your refrigerator.
More about your Advanced Water Filter
The PureSource UltraTM ice and water filter system is tested and certified to NSF/ANSI Standards 42 and 53 for the reduction of claims specified on the performance data sheet.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
Test & certification results:
•Rated Capacity - 200 gallons/757 liters for PureSource UltraTM ice and water filter
•Rated service flow
•Operating Temp.: Min. 33°F, Max. 100°F
•Maximum Rated Pressure - 100 pounds per square inch
•Recommended Minimum Operating Pressure: 30 pounds per square inch
To replace your PureSource UltraTM water filter:
It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement.
1Turn Off the ice maker power switch.
2Remove the filter by pushing on the end/face of the filter.
3Slide the old water filter cartridge straight out of the housing and discard it.
4Unpackage the new filter cartridge. Using the alignment guide, slide it gently into the filter housing until it stops against the
5Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the
6Press a drinking glass against the water dispenser while checking for any leaks at the filter housing.
Any spurts and sputters that occur as the system purges air out of the dispenser system are normal.
7After filling one glass of water, continue flushing the system for about four minutes.
8Turn On the ice maker.
9Press and hold the Water Filter button on the Ice & Water Dispenser control panel for three seconds. When the display changes from Red to Green, the status has been reset.
26
