16
CHANGING THE FILTER

More about your Advanced Water Filter

The PureSource UltraTM ice and water
ltersystemistestedandcertiedbyNSF
International, to NSF/ANSI Standards 42
and53forthereductionofclaimsspecied
on the performance data sheet.
Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection
beforeorafterthesystem.Systemscertiedforcyst
reduction may be used on disinfected waters that may
containlterablecysts.

Test & certication results:

 • RatedCapacity-200gallons/757litersfor
PureSource UltraTMiceandwaterlter
 • Ratedserviceow-.50gallonsperminute
 • OperatingTemp.:Min.33°F,Max.100°F
 • MaximumRatedPressure-100poundsper
square inch
 • RecommendedMinimumOperatingPressure:30
pounds per square inch

To replace your PureSource UltraTM water

lter:

It is not necessary to turn the water supply off to
7 Afterllingoneglassofwater,continueushing
the system for about three minutes.
8 Turn On the ice maker.
9 Press and hold the Filter Status button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from “Replace” to
“Good,” the status has been reset.
changethelter.Bereadytowipeupanysmallamounts
ofwaterreleasedduringthelterreplacement.
1 Turn Off the ice maker.
2 Removethelterbypushingontheend/faceof
thelter.
3 Slidetheoldwaterltercartridgestraightoutof
the housing and discard it.
4 Unpackagethenewltercartridge.Usingthe
alignmentguide,slideitgentlyintothelter
housing until it stops against the snap-in connector
at the back of the housing.
5 Push rmly until the cartridge snaps
into place (you should hear a click as the
cartridge engages the snap-in connector).
6 Press a drinking glass against the water dispenser
whilecheckingforanyleaksatthelterhousing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.