BEFORE YOU CALL

1-800-944-9044 (United States)

1-800-265-8352 (Canada)

Visit our web site at

www.frigidaire.com.

PROBLEM

CAUSE

CORRECTION

AUTOMATIC ICE MAKER

Ice maker is not mak-

Ice maker wire signal arm is in

• Move wire signal arm to the “down” or ON position. (side

ing any ice.

 

the “up” or OFF position.

 

mounted)

 

• Ice maker power switch is Off.

• Turn power switch to On (“I”) position. (rear mounted)

 

• Ice maker has small cube

Remove small cube from ice maker. The ice and water

 

 

caught in mechanism.

 

filter cartridge may be clogged. Replace filter cartridge.

 

• Saddle valve on cold water

Turn off household water line valve. Remove valve. En-

 

 

pipe is clogged or restricted by

 

sure that valve is not a self-piercing saddle valve. Clean

 

 

foreign material.

 

valve. Replace valve if necessary.

Ice maker is not mak-

Ice maker is producing less ice

• Side mounted ice maker should produce 4 to 4.5 pounds

ing enough ice.

 

than you expect.

 

(approximately 4 quarts) of ice every 24 hours. A rear

 

 

 

 

mounted ice maker should produce 3 to 4 pounds (ap-

 

 

 

 

proximately 3½ quarts) of ice every 24 hours. Quick Ice

 

 

 

 

option should produce up to 50% more ice every 24 hours.

 

• Check to see if water dispenser

• If it is, replace the ice and water filter cartridge.

 

 

is dispensing slower than normal.

 

 

Ice maker will not stop

Ice maker wire signal arm is

Move item and release wire signal arm. Remove any ice

making ice.

 

being held down by some item

 

cubes that are frozen together over the wire signal arm.

 

 

in the freezer.

 

 

Ice cubes are freezing

Ice cubes are not being used

Remove ice container and discard ice from container. Ice

together.

 

frequently enough.

 

maker will produce fresh supply.

 

• Ice cubes are hollow (partially

The ice and water filter cartridge may be clogged. Replace

 

 

frozen cubes with water inside).

 

filter cartridge.

 

• Freezer control is set too warm.

Set freezer control to colder setting. Allow 24 hours for

 

 

 

 

temperature to stabilize.

ICE DISPENSER

 

 

 

 

 

 

 

 

Dispenser will not dis-

Ice storage container is empty.

• When the first supply of ice is dropped into the container,

pense ice.

 

 

 

the dispenser should operate.

 

• Freezer temperature is set too

• Turn freezer control to a higher setting so that ice cubes

 

 

warm.

 

will be made. When first supply of ice is made, dispenser

 

 

 

 

should operate.

 

• Household water line valve is

Open household water line valve. Allow sufficient time

 

 

not open.

 

for the ice to be made. When ice is made, the dispenser

 

 

 

 

should operate.

 

• Ice dispensing arm has been held

Motor is overloaded. Motor over load protector will reset in

 

 

in for more than 4-5 minutes.

 

approximately 3 minutes. Ice can then be dispensed.

Ice dispenser is

Ice has melted and frozen

• Remove ice container, thaw, and empty the contents.

jammed.

 

around auger due to infrequent

 

Clean container, wipe dry, and replace in proper position.

 

 

use, temperature fluctuations,

 

When new ice is made, dispenser should operate.

 

 

and/or power outages.

 

 

 

• Ice cubes are jammed between

• Remove ice cubes that are jamming the dispenser.

 

 

ice maker and back of ice

 

 

 

 

container.

 

 

OPENING/CLOSING OF DOORS/DRAWERS

 

 

 

 

 

 

Door(s) will not close.

Door was closed too hard, caus-

• Close both doors gently.

 

 

ing other door to open slightly.

 

 

 

Refrigerator is not level. It

• Ensure floor is level and solid, and can adequately support

 

 

rocks on the floor when moved

 

the refrigerator. Contact a carpenter to correct a sagging

 

 

slightly.

 

or sloping floor.

 

• Refrigerator is touching a wall

• Ensure floor is level and solid, and can adequately support

 

 

or cabinet.

 

the refrigerator. Contact a carpenter to correct a sagging

 

 

 

 

or sloping floor.

Drawers are difficult to

Food is touching shelf on top of

• Remove top layer of items in drawer.

move.

 

drawer.

• Ensure drawer is properly installed on track.

 

• Track that drawers slide on is

Clean drawer, rollers, and track. See Care & Cleaning.

 

 

dirty.

 

 

19

Page 19
Image 19
Frigidaire LGHC2342LF3, FGHC2342LF, FPHS2386LF7, FPHC2398LF, FPUS2686LF Before YOU Call, United States Canada