GAS COOKTOP INSTALLATION INSTRUCTIONS
1. Wall Outlet Location
Figure 5
2. Cooktop Installation
1. Visually inspect the cooktop for damage.
2. Set the cooktop into the countertop cutout.
After inserting the cooktop into the countertop opening, make sure the unit is sitting on the metal flange around the top of the burner box. Cooktop must not sit on the glass or the porcelain top. Avoid cutting an oversized hole in the countertop.
NOTE: Do not use caulking compound; cooktop should be removable for service when needed.
Granite countertop Installation Kit
A Granite Countertop Installation kit # 903103- 9010 can be ordered through an Electrolux Service Center.
Clamp Down Information
Seal
Cooktop Countertop
Angle
Bracket
Thumb
Screw
Figure 6
Once the cooktop is installed in the counter opening, you must clamp the unit down as shown. To clamp down, insert an angle bracket into the slot on each side of the unit as shown. Run thumb screw up through the bracket, up against the bottom of the counter. Tighten until the unit draws down and is secure.
3. Provide an Adequate Gas Supply
This cooktop is designed to operate on natural gas at 4" of manifold pressure only.
A pressure regulator is connected in series with the manifold on the cooktop and must remain in series with the supply line.
For proper operation, the maximum inlet pressure to the regulator must be no more than 14" of water column (W.C.) pressure.
For checking the regulator, the inlet pressure must be at least 1" (or 2.5 kPa) greater than the regulator manifold pressure setting. The regulator is set for 4" of manifold pressure, the inlet pressure must be at least 5".
The gas supply line to the range should be 1/2" or 3/4" pipe.
4. LP/Propane Gas Conversion
This appliance can be used with Natural gas or LP/Propane gas. It is shipped from the factory for use with natural gas.
A kit for converting to LP gas is supplied with your cooktop. The kit is marked "FOR LP/PROPANE GAS CONVERSION".
The conversion must be performed by a qualified service technician in accordance with the kit instructions and all local codes and requirements. Failure to follow instructions could result in serious injury or property damage. The qualified agency performing this work assumes responsibility for the conversion.
WARNING Failure to make the appropriate conversion can result in serious personal injury and property damage.
Important: Remove all packing material and literature from cooktop before connecting gas and electrical supply to cooktop.
6