GAS COOKTOP INSTALLATION INSTRUCTIONS
6. Electrical Requirements
120 volt, 60 Hertz, properly grounded branch circuit protected by a 15 amp circuit breaker or time delay fuse. Do not use an extension cord with this cooktop.
Grounding Instructions
IMPORTANT Please read carefully.
For personal safety, this appliance must be properly grounded.
The power cord of this appliance is equipped with a
The wall receptacle and circuit should be checked by a qualified electrician to make sure the receptacle is properly grounded.
Where a standard
7. Check Operation
Refer to the Use and Care Guide packaged with the cooktop for operating instructions and for care and cleaning of your cooktop.
1. | Remove foam caps. |
2. Turn on Electrical Power and Open Main | |
| Shutoff Gas Valve |
3. | Check the Igniters |
| Operation of electric igniters should be |
| checked after cooktop and supply line |
| connectors have been carefully checked for |
| leaks and the cooktop has been connected to |
| electric power. |
| To operate the surface burner: |
| A. Push in and turn a surface burner knob |
| to the LITE position. You will hear a small |
| ticking noise; this is the sound of the |
| electric ignitor which lights the burner. |
| B. After the burner lights, turn to the desired |
| flame size. The controls do not have to be |
Preferred Method
Grounding type wall receptacle
Do not, under any circumstances, cut, remove,
or bypass the grounding prong.
Power supply cord with
Figure 9
set at a particular mark. Use the marks as |
a guide and adjust the flame as needed. |
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
WARNING Disconnect electrical supply cord from wall receptacle before servicing cooktop.
8