Frigidaire FPHD2491 Options Selections, Operating Instructions, Getting Started, Hi-Temp Wash

OPERATING INSTRUCTIONS

									1-24 hrs		sanitized
power	normal	light	energy	china	rinse	sanitize	hi temp	air	delay	START
plus	wash	wash	saver	crystal	only		wash	dry	start	cancel
						add rinse aid			hold to lock

Options Selections

Getting Started

1.Load dishwasher (See Preparing and Loading Dishes).

2.Add detergent (See Dishwasher Dispenser & Detergents).

3.Add rinse aid (See Rinse Aid).

4.Select desired CYCLE (See Cycle Chart). The indicator light above the pad will glow when selected.

5.Select desired OPTIONS (See Energy Options). The indicator light above the pad will glow when selected.

6.Run hot water faucet nearest dishwasher until water is hot. Turn water off.

7.To start, press START/CANCEL pad.

8.Close door to latch.

NOTE

The dishwasher is programmed to remember your last cycle so you do not have to reset each time. To start the dishwasher using the same cycle and options selected on the previous wash, just press the START/CANCEL pad.

Wash Cycle Selections

Cycle times are approximate and will vary with options selected. Hot water is necessary to activate dishwasher detergent and melt fatty food soils. An automatic sensor will check the incoming water temperature and, if it is not hot enough, the timer will be delayed for automatic water heating in the main wash of all cycles. This happens even when HI-TEMP WASH option has not been selected. When HI-TEMP WASH is selected, an even higher temperature will be guaranteed to handle heavier

soil loads.

Hi-Temp Wash

When HI-TEMP WASH option is selected, the dishwasher heats water in the main wash to approximately 140°F (60°C).

This increase in water temperature helps

dishwasher detergent remove food grease and soil from dishes more effectively and aids in drying. This option is available in NORMAL WASH and LIGHT WASH. HI-TEMP WASH is automatically provided when POWER PLUS cycle is selected.

5