OPERATING INSTRUCTIONS
Status Indicator Lights
|
|
|
|
|
|
|
|
|
|
|
| sanitized | |
power | normal | light | energy | china | rinse | sanitize | hi temp | air | delay | START |
|
|
|
plus | wash | wash | saver | crystal | only | wash | dry | start | cancel |
|
|
| |
|
|
|
|
|
| add rinse aid |
|
| hold to lock |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PF……………… | Appears in window when |
| dishwasher is first |
| installed, or when power |
| has been interrupted. HI- |
| TEMP WASH and NO |
| HEAT DRY indicator lights |
| will also flash. To clear, |
| touch START/CANCEL |
| pad. |
Number of delay start | |
| hours. Count down are in |
| hours. |
Cd……………… | Close dishwasher door. |
| The status indicator |
| lights will also flash to |
| indicate current cycle |
| status. |
MINUTES…...… | Number of minutes left in |
| cycle |
NOTE
The time remaining could suddenly increase or drop several minutes. This means the Smart Sensor has checked the soil level and determined if additional water
fills are needed or if water fills can be deleted.
sanitized
When the SANITIZE option is selected, the SANITIZED light will glow when the SANITIZE cycle is finished and remain on for 30 seconds after the door is opened. If the dishwasher did not properly sanitize the dishes, the light will not come on. This can happen if the cycle is interrupted or if incoming water temperture is below 120oF.
The CLEAN light will come on at the end of the cycle. When the door is opened at end of cycle and remain on for 30 seconds after door is opened.
The add RINSE AID light, Located near the Rinse Only Pad, comes on at the end of a cleaning cycle when the rinse agent reservoir is low. The light will remain on through 5 successive cycles or until the reservoir is filled.
In the unlikely event the dishwasher malfunctions, the indicator may display one of the following codes "Er", or "CE". If one of these codes are displayed contact the
Frigidaire Customer Care Center at
service technician, if needed.
8