Mossew 27INST FR 04/09 | Frigidaire FPMO209KF guide

27" Combination Installation

Built-In Microwave / Single Wall Oven

27" Combination Installation Specifications

•Always consult local and national electric codes.

(Refer to product-specific electrical specifications on this page.)

•Minimum 23-1/2" deep cutout dimension is critical for proper combination installation, to ensure that each built-in product’s faceplate will fit flush against cabinet front.

•Bases must be level and cabinet front must be square.

•Minimum 4-1/2" required distance from bottom of Wall Oven cutout to floor, 31" suggested.

•Respect critical dimensions as noted for proper installation of built-In products.

•Minimum 21" clearance needed for Wall Oven door depth when open.

27" Electric Single Wall Oven Specifications

•Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line.

•For detailed electrical requirements, refer to model-specific product page and installation guide on web.

•Full base of solid plywood or similar material required, capable of supporting 200 Lbs.

•To adapt oven to fit cutout height greater than 28-1/8", add one 2"-wide wood shim of appropriate height to each side of opening under oven side rails. Lifting oven will hide larger cutout opening at top and oven’s 1"-high bottom trim will hide shims at bottom. (Standard 1"- High Bottom Trim included.)

27" Built-In Microwave Specifications

•For built-in installation, microwave MUST be installed with optional 27" Trim Kit which includes Bottom Duct Assembly – shipped in separate box, ordered by individual part number.

•Voltage Rating – 120V / 60 Hz / 15 or 20 Amps

•Connected Load (kW Rating) @ 120 Volts = 1.7 kW

(For use on adequately wired 120V, dedicated circuit having 2-wire service with a separate ground wire. Appliance must be grounded for safe operation.)

•Amps @ 120 Volts = 14.3 Amps

•Full base of solid plywood or similar material required, capable of supporting 100 Lbs.

•Minimum 2-7/8" clearance required from bottom of Built-In Microwave cutout to top edge of Wall Oven’s faceplate, leaving a 2" visible gap between both product faceplates.

Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions.

FRIGIDAIRE®

USA • 250 Bobby Jones Expressway • Martinez, GA 30907 • 1-800-FRIGIDAIRE • frigidaire.com

CANADA • 5855 Terry Fox Way • Mississauga, ON L5V 3E4 • 1-800-265-8352 • frigidaire.caSpecifications subject to change.