Operating Instructions
Operating Instructions
(continued)
TIMER: DELAY STOP / START FEATURE | YOU WILL SEE HOW MUCH TIME IS CHOSEN: | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FIRST
DO THIS:
PRESS
TIMER BUTTON
THEN
DO THIS:
PRESS
UP/DOWN BUTTONS
Note: For Delay Stop, the unit must be in the On position.
Note: For Delay Start, the unit must be in the Off position.
First, Press TIMER button, then adjust timer setting, tap or hold the UP arrow ( 
) or the DOWN arrow ( 
) to change delay timer at 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7.5, 7, etc.). The Delay Start Operation automatically selects cooling with maximum Fan speed (if Cool, Energy Saver, or Fan Only was the last mode selected) . The temperature maintained will be the same as previously set. To change the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5 seconds, the control will automatically change the display back to the hours remaining until the unit will start/stop. Pressing the unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens the above steps have to be repeated again.
CHECK FILTER FEATURE, YOU WILL SEE:
Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter Reset" button and the light will go off.
DO THIS:
PRESS FILTER RESET BUTTON
FAULT CODES:
If the display reads "AS" , a sensor has failed. Contact your Authorized Frigidaire Service Center.
If the display reads "ES" , a sensor has failed. Contact your Authorized Frigidaire Service Center.
8 | 2009 Electrolux Home Products, Inc. | All rights reserved. |
|
| |
|
|
