NOTE: Remote display is actual temperature at remote control only

Operating Instructions

Operating Instructions

(continued)

REMOTE SENSING FEATURE (on some models)

LIGHT pulsing ( On & Off intermittently ).

DO THIS:

PRESS REMOTE

SENSING

START BUTTON

NOTE: Unit display shows the set temperature

Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.

To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Next, use the “ ” buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself ). The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal. lt will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button. lf the unit does not receive the remote sensing signal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has ended. The display on the remote control indicates the temperature at the remote ONLY.

NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the unit.

HEATING FEATURE(on some models):

YOU WILL SEE:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

DO THIS:

PRESS MODE BUTTON,

CHOOSE HEAT

Note: This feature can be used with any combination of FAN Speeds (Low speed only on 115V models), Timer, or Sleep Modes. When in the "Heat" mode,the fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between 55 °F(13 °C) and 80 °F(27 °C) (The upper limit of temperature could reach 86°F(30 °C) on some of the 115V models.). When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air.

FAULT CODES:

If the display reads "HS", ”AS”, ”ES”, ”CS” or ”OS”, a sensor has failed. Contact your Authorized Frigidaire Service Center.

2009 Electrolux Home Products, Inc.

All rights reserved.

9

 

 

 

 

 

 

Page 9
Image 9
Frigidaire FRA18EMU2, FRA296ST2, FRA256SV2, FRA186MT2 Heating FEATUREon some models, Remote Sensing Feature on some models: