Front Load Dryer

FRQE7000L W 7.0 Cu. Ft. Electric

Front Load Dryer Specifications

Product Shipping Weight (approx.) – 129 Lbs.

An electrical supply with grounded three-prong receptacle is required.

Voltage Rating – 240V / 60 Hz / 30 Amps

Single phase 3- or 4-wire cable, 240 Volt, 60 Hertz AC only electrical supply with ground required on separate circuit fused on both sides of line. (Do not use same circuit as washer.)

Connected Load (kW Rating) @ 240 Volts = 5.0 kW

Amps @ 240 Volts = 24 Amps

Dryer MUST employ a 3-conductor NEMA 10-30 type SRDT or

4-conductor NEMA 14-30 type SRDT or ST (as required), rated at 240 volt AC minimum, 30 amp power supply cord marked for use with clothes dryers (not supplied).

Grounding through neutral link prohibited in specific applications and certain locales, requiring use of 4-wire system. (For detailed electrical requirements, refer to Product Installation Guide on web.)

Always consult local and national electric codes.

Can be installed alone, with or without optional 15" Drawer Pedestal, or stacked above matching Frigidaire® Washer, which requires installation of optional Dryer Stacking Kit. (For installation details, refer to instructions included with optional pedestal or stacking kit or on web.)

Can be built in with matching Frigidaire® Washer in under-counter, recessed or closet installation. (Refer to Built-In Installations on this page for cutout dimensions. For additional installation details, refer to Product Installation Guide on web.)

Closet installation requires vented door with 2 unobstructed louvered openings, minimum 60 sq. in. each, located 3" from top and bottom of door. Full-length 120 sq. in. opening also acceptable. Allow additional 1" clearance between fronts of units and closed door.

Do NOT install in area exposed to dripping water or outdoor weather conditions; where gasoline or other flammables are kept or stored; or where dryer comes in contact with curtains, drapes or anything that will obstruct flow of combustion and ventilation air.

For garage installation, dryer MUST be located minimum 18" above floor.

Floor MUST be solid with 1" maximum slope. Do NOT install on carpeted surface.

Dryer MUST exhaust to outside of building, NOT into any concealed space.

Exhaust installation requires minimum 4"-diameter rigid or flexible metal duct with approved vent hood having swing-out damper(s). Do NOT use flexible plastic or metal foil duct and use shortest run possible.

Leveling legs supplied to level dryer properly and reduce excessive noise and vibration.

Note: For planning purposes only. Refer to Product Installation Guide on the web at frigidaire.com for detailed instructions.

Optional Accessories

Dryer Stacking Kit – (PN # STACKIT7X).

15" Classic White Drawer Pedestal – (PN # CFPWD15W).

Mobile Home Installation Kit – (PN # 137067200).

Drying Rack – (PN # 137067300).

USA 10200 David Taylor Drive Charlotte, NC 28262 1-800-FRIGIDAIRE frigidaire.com

Specifications

CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4 1-800-265-8352 frigidaire.ca

subject to change.

FRQE7000L 10/10

© 2010 Electrolux Home Products, Inc.

Printed in the U.S.A.

Page 3
Image 3
Frigidaire FRQE7000L W dimensions Front Load Dryer Specifications, Optional Accessories