* White Westinghouse uses the name CrystalClear instead of PureSource, but they are the same filter 15
• Rated Capacity - 400 gallons
• Rated service flow - .5 GPM
• Maximum Rated Pressure - 100 PSI
• Maximum Operating Temp. - 100° F
IMPORTANT: Resetting The Filter Status Light (some models)
After replacing the filter cartridge, it will be necessary to press the Filter Status reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.
On models without a Filter Status reset button, there is a set of Reminder Stickers included in the envelope that the Use & Care Manual came in. Choose a dated sticker that indicates 6 - 9 months (depending on your water quality and usage) from the date of installation. Place the sticker on the front of the filter cup to remind you when it is time to change the filter.
Order new filter cartridges through the dealer where you bought the refrigerator, or contact the Consumer Assistance Center at 1-800-944-9044. It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the RG-100PureSource ™* replacement cartridge.
The PureSource™ * NGRG-
2000 Ice and Water Filter System with the RG-100 cartridge is tested and certified by NSF International,
the nationally recognized and respected, not for profit, certification organization for public health safety. The PureSource™ * system is tested and certified to ANSI/NSF Standard 42. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.
Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after 400 gallons of water has flowed through the ice and water dispenser (some models). Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed).
To change filter:
It is not necessary to turn the water supply off to change the filter.
1. Open freezer door and leave open until filter change is complete.
2. Set ice maker wire signal arm to the OFF (up) position (See illustration on page 13).
3. Hold filter cup firmly, and unscrew towards left (Some water could
leak out as you remove cup. This is normal.). Filter cartridge should come down with cup. If cartridge remains in housing, pull down gently, while twisting filter back and forth.
4. Rinse out cup under running water.
5. The large o-ring that seals the filter system sets in the o-ring groove down inside the cup. Should the o-ring fall out during filter cartridge replacement, simply place it back in the groove prior to screwing the cup back in place. If the o-ring becomes damaged, you will need to order one from the Consumer Assistance Center.
6. Discard old filter cartridge.
7. Remove new filter cartridge from packaging and place in cup. The end with the small o-ring should be up, out of the cup.
8. Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall Cup. Filter cartridge will self-align as cup is tightened. Be sure cup is completely tightened with PureSource™ logo facing outward. Do Not
Tighten Past Stop.
9. Set ice maker wire signal arm to the ON (down) position.
10. Check for leaks. Open refrigerator door. Wipe any water droplets from the filter cup. Fill a glass with water. If there is a leak, unscrew filter cup, and reinsert the filter cartridge. Check placement of large O-ring. Reinstall filter cup, making certain it is tightened completely.
11. To condition filter system and purge air from water line, fill a glass with water. Continue flushing the system for approximately 3 minutes to assure that the purest water possible is stored in water tank.
System Startup:
Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section
to properly fill the system with water. Changing the Filter:

Automatic Ice and Water Dispenser

PureSource TM * Ice and Water Filter (some models)

NOTE: If you purchased a refrigerator with a PureSource TM * Ice and Water filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right back corner of the fresh food compartment.

Page 14 Page 16
Page 15
Image 15
Frigidaire FRS26HF7BB0, FRS23H5ASB3, FRS23KR4AW5, FRS23KR4AB5, FRS26HR4AB3 PureSource TM * Ice and Water Filter some models
Page 14 Page 16

FRS26HR4AQ3, FRS23H5ASB3, FRS26HF7BB0, FRS23KR4AW5, FRS26HR4AB3 specifications

The Frigidaire FRS26HF7BW0, FRS26HR4AW3, FRS23KR4AB5, FRS26HR4AB3, and FRS23KR4AW5 are a collection of reliable side-by-side refrigerators known for their blend of functionality, style, and innovative features. These models are designed to cater to the needs of modern households while ensuring efficient refrigeration and freezing.

One of the prominent features of these Frigidaire models is their spacious interior, which provides ample storage options. The refrigerators come with adjustable shelves that allow users to customize the storage space according to their needs. With a combination of clear crisper drawers and fixed shelving, organization becomes easy and convenient, promoting an efficient kitchen environment.

Additionally, these refrigerators are equipped with the Advanced Filtration Technology, which ensures that the water and ice dispensed are free from impurities. This feature not only guarantees better-tasting water but also enhances the overall quality of drinks served from the refrigerator.

The exterior design of these Frigidaire models includes a water and ice dispenser, providing quick access to refreshing drinks. The models come with a stylish finish that complements various kitchen decors, seamlessly fitting into any home environment. The LED lighting featured inside brightens every corner, making it easier to locate items even in low-light conditions.

Energy efficiency is a key characteristic of the FRS series. These refrigerators are ENERGY STAR certified, which means they meet strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. This certification indicates that they consume less electricity compared to standard models, helping homeowners to save on energy bills.

Another essential attribute is the Frost-Free Defrost System, which helps prevent ice buildup in the freezer compartment. This technology simplifies maintenance and ensures that users can access frozen items without hassle. Furthermore, the models are constructed with durable materials that promise longevity and reliability.

In terms of capacity, each model has been designed with family needs in mind, providing plenty of room for groceries and larger items like party platters or bulk purchases. The thoughtful arrangement of shelves and bins helps to keep items organized and easily accessible.

In summary, the Frigidaire FRS26HF7BW0, FRS26HR4AW3, FRS23KR4AB5, FRS26HR4AB3, and FRS23KR4AW5 refrigerators stand out for their user-friendly features, energy efficiency, and spacious interiors. They embody Frigidaire's commitment to quality and innovative technology, making them an excellent choice for any home looking to enhance their kitchen experience.
Top Page Image Contents