* White Westinghouse uses the name CrystalClear instead of PureSource, but they are the same filter 18
• Rated Capacity - 400 gallons
• Rated service flow - .5 GPM
• Maximum Rated Pressure - 100 PSI
• Maximum Operating Temp. - 100° F
IMPORTANT: ResettingThe Filter Status Light (some models)
After replacing the filter cartridge, it will be necessary to press the Filter Status reset button located on the ice and water dispenser. This will reset the Filter Status light. Push the reset button until the green, red and amber lights flash (10-15 seconds). Please refer to the complete dispenser operating instructions attached to the inside of the freezer door.
On models without a Filter Status reset button, there is a set of Reminder Stickers included in the envelope that the Use & Care Manual came in. Choose a dated sticker that indicates 6 - 9 months (depending on your water quality and usage) from the date of installation. Place the sticker on the front of the filter cup to remind you when it is time to change the filter.
The PureSource™ * NGRG-
2000 Ice and Water Filter System with the RG-100 cartridge is tested and certified by NSF International,
the nationally recognized and respected, not for profit, certification organization for public health safety. The PureSource™* system is tested and certified to ANSI/NSF Standard 42. See performance data sheet for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.
Tighten Past Stop.
9. Turn the ice maker’s power switch to the On (“I”) position.
10. Check for leaks. Open refrigerator door. Wipe any water droplets from the filter cup. Fill a glass with water. If there is a leak, unscrew filter cup, and reinsert the filter cartridge. Check placement of large O-ring. Reinstall filter cup, making certain it is tightened completely.
11. To condition filter system and purge air from water line, fill a glass with water. Continue flushing the system for approximately 3 minutes to assure that the purest water possible is stored in the water tank.
Order new filter cartridges through the dealer where you bought the refrigerator, contact the Customer Care Center at 1-800-944-9044, or go to our web site at www.frigidaire.com. It might be good to order some filter cartridges when you first install your refrigerator. Be sure to ask for the RG-100PureSource™* replacement cartridge.
Water conditions vary throughout the world, but changing the water filter every 6 - 9 months normally will ensure the highest possible water quality. The Filter Status light will turn red after 400 gallons of water has flowed through the ice and water dispenser (some models). Also, if the filter has been in a refrigerator that has not been in use for awhile (during moving for example), change the filter before reinstalling the refrigerator. The dispenser system will also operate without filtration (with filter cartridge removed).
To change filter:
It is not necessary to turn the water supply off to change the filter.
1. Open freezer door and leave open until filter change is complete.
2. Turn the ice maker’s power switch to the Off (“O”) position (See illustration on page 16).
3. Hold filter cup firmly, and unscrew towards left (Some water could
leak out as you remove cup. This is normal.). Filter cartridge should come down with cup. If cartridge remains in housing, pull down gently, while twisting filter back and forth.
4. Rinse out cup under running water.
5. The large o-ring that seals the filter system sets in the o-ring groove down inside the cup. Should the o-ring fall out during filter cartridge replacement, simply place it back in the groove prior to screwing the cup back in place. If the o-ring becomes damaged, you will need to order one from the Customer Care Center.
6. Discard old filter cartridge.
7. Remove new filter cartridge from packaging and place in cup. The end with the small o-ring should be up, out of the cup.
8. Screw cup, with filter, back onto housing. Do Not Use Wrench To Reinstall Cup. Filter cartridge will self-align as cup is tightened. Be sure cup is completely tightened with PureSource™ logo facing outward. Do Not
System Startup:
Water supply does not need to be turned off, however, do not use ice and water dispenser while installing filter. The filter cartridge has already been installed in the filter housing at the factory. Refer to the How The Water Dispenser Works section
to properly fill the system with water. Changing the Filter:

Automatic Ice and Water Dispenser

PureSource TM * Ice and Water Filter (some models)

NOTE: If you purchased a refrigerator with a PureSource TM * Ice and Water filter, please read the following use and care information. This ice and water filter system filters water to your ice maker and water dispenser. It is located in the upper right back corner of the fresh food compartment.

Page 17 Page 19
Page 18
Image 18
Frigidaire FRS6B5EEW1, FRS6L7EES5, FRS6L7EES1, FRS6B5EEQ1 manual PureSource TM * Ice and Water Filter some models
Page 17 Page 19

FRS6L7EES5, FRS6B5EEQ1, FRS6L7EES1, FRS6B5EEW1 specifications

The Frigidaire FRS6B5EEW1, FRS6L7EES1, FRS6B5EEQ1, and FRS6L7EES5 are highly efficient side-by-side refrigerators known for their cutting-edge features that enhance user convenience and food preservation. These models are designed with practicality in mind, providing a blend of functionality and style that suits various kitchen designs.

One of the standout features of these Frigidaire refrigerators is their spacious interior layout. The side-by-side design offers a generous amount of storage space with easy access to both fresh and frozen foods. With adjustable shelves, door bins, and humidity-controlled crisper drawers, users can organize their groceries efficiently, making use of every bit of available space.

In terms of technology, these models are equipped with advanced temperature management systems that ensure optimal cooling performance. The EvenTemp cooling system helps maintain consistent temperatures throughout the fridge, preventing hotspots and preserving food freshness longer. Additionally, the built-in ice maker provides a continuous supply of ice, ideal for entertaining or everyday use.

Energy efficiency is another key characteristic of the FRS models. They are designed to meet or exceed Energy Star guidelines, which means they consume less energy compared to many traditional refrigerators. This not only reduces utility bills but also contributes positively to environmental sustainability.

The exterior finish of these refrigerators is sleek and stylish, with options available in classic white or stainless steel to match various kitchen aesthetics. The easy-to-clean surface helps maintain a tidy look while resisting fingerprints and smudges.

Moreover, these Frigidaire models come with user-friendly digital controls that make setting and adjusting temperatures a breeze. The LED lighting illuminates the interior, allowing users to locate items easily, even in low light.

Overall, the Frigidaire FRS6B5EEW1, FRS6L7EES1, FRS6B5EEQ1, and FRS6L7EES5 refrigerators stand out for their combination of spaciousness, energy efficiency, and innovative cooling technologies. They are an excellent choice for families or anyone looking to enhance their kitchen with a reliable appliance that caters to their daily needs while maintaining a modern flair. Whether you're focused on convenience, energy savings, or just want a stylish addition to your home, these Frigidaire models offer it all.
Top Page Image Contents