![](/images/new-backgrounds/1246938/24693811x1.webp)
Connecting drain and electrical
1. | Form a “U” shape on the end of the drain hose with the hose |
| |||
| pointed toward the drain. Place the formed end in a laundry |
| |||
| tub or a standpipe and secure with a cable tie provided in the |
| |||
| enclosure package. |
| |||
2. | Place the hook end of the drain hose in the drain opening. |
| |||
| Secure the drain hose with the cable tie (provided in the |
| |||
| enclosure package) to the standpipe, inlet hose, laundry tub, |
| |||
| etc. so the hose does not pull out from the force of the water. | CABLE TIE | |||
|
|
| The standpipe inside diameter must be |
| |
|
|
|
| ||
|
| cm) minimum. There must be an air gap around the drain hose |
| ||
|
| in the standpipe. A snug hose fit can cause a siphoning action. |
| ||
|
|
|
| Check to ensure the power is off at circuit |
|
|
|
|
|
| |
|
| breaker/fuse box before plugging the power cord into outlet. |
| ||
3. | Plug the power cord into a grounded outlet. |
|
Grounding type wall receptacle
Do not, under
any circumstances, cut, remove,
or bypass the grounding prong.
Power cord with
4. Turn on the power at circuit breaker/fuse box.
5.Carefully slide the washer to its final position. Recheck for level and rock corners for stability.
6. Read the Use & Care Guide provided with the washer. It contains valuable and helpful information that will save you time and money.
7.Run the washer through a complete cycle, checking for water leaks and proper operation.
8.If you have any questions during initial operation, please review the “Service Prevention Checklist” in your Use & Care Guide before calling for service.
9.Place these instructions in a location near the washer for future reference.
A wiring diagram and technical data sheet are located inside the washer console.
Replacement parts:
If replacements parts are needed for your washer, contact the source where you purchased your washer.
- ELECTRICAL SHOCK HAZARD - Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.
6