Frigidaire FTW3014KW, 137153100A (0903) Installed Washer Dimensions, Unpacking Instructions

water supply connection on

rear of washer, inlet hose length

approximately 43” (109 cm)

drain hose retention clamp

on rear of washer, loose hose length beyond clamp approximately 54” (137 cm)

Installed Washer Dimensions

power cord length on rear of

washer approximately 59” (150 cm)

51” (129.5 cm)

to clear open lid

43 5/8”

(111 cm)

36”

(91.5 cm)

24”

(61 cm)

27” (68.6 cm) 27” (68.6 cm)

Unpacking Instructions

To prevent vibration, possible machine dam- age and maximize performance, the following steps must be completed.

1. If foam tub block has been removed, reinsert it now and retape the lid securely.

2.Using a rug, blanket or piece of cardboard to protect the floor, carefully lay the washer on its left side.

PLASTIC	WIRE CLIP
SPACER

SHIPPING

BOLT

PLASTIC

CLIP

3.Using a ratchet with 3/8” socket, remove the mechanism shipping bolt and plastic spacer block from the center of the base.

If the washer is to be transported at a later date, the tub blocking pad, shipping bolt, and plastic spacer block should be retained.

4.Carefully return the washer to an upright position.

5.Remove the tape holding the lid shut and open the lid.

6.Remove the foam tub block.

7.Remove the inlet hoses and other tub contents.

8.From the back of the washer, remove the wire shipping clip securing the drain hose.

9.DO NOT remove the PLASTIC CLAMP which secures the drain hose to the right side of the washer backsheet. It helps form a standpipe to prevent water siphoning.

10.Carefully move the washer to within 4 feet of the final location for the start of the installation.

4