Frigidaire Gas Wall Oven Avoid Service Checklist, Oven Control Beeps and Displays -F1, F3- or -F9

Avoid Service Checklist

Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

This oven is equipped with an electronic oven controller (some models). Among its many features is a full time oven circuit diagnostics system. The controller constantly monitors its internal circuitry as well as several crucial oven circuits, to insure they are all operating correctly. If at any time one of these systems fail, the controller will immediately shut down operation, and will beep and flash an error code of -F1-, -F3- or -F9- in the display window.

OCCURRENCE	POSSIBLE CAUSE/SOLUTION
Oven Control Beeps and Displays -F1-	Electronic control has detected a fault condition. Push CANCEL to clear the display
-F3- or -F9-.	and stop the display from beeping. Reprogram the oven. If a fault reoccurs, record
	the fault number, push the CANCEL pad and contact an authorized servicer.
Oven is not level.	Poor installation. Place a level on an oven rack in center of oven. Contact installing
	agent if rack is not level.
	Kitchen cabinet misalignment may make oven appear to be unlevel. Be sure cabinets
	are square and level. Contact cabinet maker to correct problem.
Entire appliance does not operate.	Make sure cord/plug is securely plugged into electrical outlet.
	Cord/plug is not installed or connected. Contact your dealer, installing agent or
	authorized servicer.
	Service wiring not complete. Contact your dealer, installing agent or authorized
	servicer.
	Power outage. Check house lights to be sure. Contact your local electric company.
	Short in cord/plug. Replace cord/plug.
	Controls are not set properly. See instructions in the Oven Control Guide to set the
	controls.
	House fuse has blown or circuit breaker has tripped immediately following installation.
	House fuse may not be fully engaged. Check fuse or engage circuit breaker securely.
	House fuse has blown or circuit breaker has tripped after the oven has been installed
	and previously operating. Call an authorized servicer.
	Wall oven is not properly connected to gas supply. Check connection (see Installation
	Instructions).
Oven does not operate.	Make sure gas supply shut-off valve is opened before turning on the oven after
	installing the wall oven.
Oven light does not work.	Burned out or loose bulb. Follow instructions under Changing Oven Light to replace
	or tighten the bulb.

17