Air Conditioner Features
(continued)
TO OPERATE ON FAN ONLY: | LIGHT On | YOU WILL SEE: |
|
|
DO THIS:
PRESS
MODE BUTTON
CHOOSE
FAN ONLY
Note: Use this function only when cooling is not desired, such as for room air circulation or to exhaust stale air. (Remember to open the vent during this function, but keep it closed during cooling for maximum cooling efficiency.) You can choose any fan speed you prefer. (Exc- ept "Auto Temp").
During this function, the display will show the actual room temperature, not the set temperature as in the cooling mode. Fan Only cannot be selected when the unit is in the 'Remote Sensing' Mode. (On those units with that feature).
TO USE THE |
|
|
ENERGY SAVER FEATURE: | LIGHT On | YOU WILL SEE: |
DO THIS:
PRESS
MODE BUTTON
CHOOSE
ENERGY SAVER
Note: In this mode, the fan will continue to run for another 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the the cooling system turns back on.
TIMER: DELAY START/STOP FEATURE: | LIGHT On | YOU WILL SEE HOW MUCH TIME IS CHOSEN: | |
| FIRST |
|
|
| DO THIS: |
|
|
| PRESS |
|
|
TIMER BUTTON |
|
| |
| THEN |
|
|
| DO THIS: |
|
|
| PRESS |
|
|
| TEMP/TIMER |
|
|
| SET BUTTON |
|
|
Note 1: For Delay Stop, the unit must be in the On position. |
|
|
|
Note 2: For Delay Start, the unit must be in the Off position. |
|
|
|
First, PRESS TIME BUTTON |
|
|
|
Then to adjust timer setting, tap or hold the UP arrow ( ▲ ) or the DOWN arrow ( | ▲ | ) to change delay timer at. 5 hour increments, up to 10 | |
hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7.5, 7, etc.). The Delay Start
mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the same as previously set. To change the set temperature, press "COOL" then Up or Down arrows until the desired temperature is indicated on the display. After 5 seconds, the con- trol will automatically change the display back to the hours remaining until the unit will start/stop. PRESSING the unit On/Off button at any time will cancel the Delay Start/Stop function. The Delay Start/Stop Feature will work until the unit either starts or stops. Once that happens he above steps have to be repeated again.
7
