iftstallatio - connecting Ice Maker To Water Supply
To avoid eJectric shock, which can cause death from eJectricaJ power before connecting a water supply
To Avoid Property Damage:
or severe personaJ injury, disconnect the refrigerator line to the refrigerator.
oCopper tubing is recommended for the water suppJy Jine.Water supply tubing made of ¼"" plastic is not recommended since it greatly increases the potentiaJ for water leaks. Manufacturer will not be responsiMe for any damage if plastic tubing is used for supply line.
oDO NOT install water supply tubing in areas where temperatures fai! beJowfreezing.
oChemicaJs from a maffunctioning softener can damage the ice maker, if the ice maker is connected to soft water, ensure that the softener is maintained and working properly.
IMPORTANT: Ensure that your water supply line connections comply with all local plumbing codes,
Before/nstafling The Water Supply Line, You Wifl Need
,, BasicTools: adjustable wrench, flat=blade screwdriver, and Phillips TM screwdriver
oAccess to a household cold water line with water pressure between 20 and 100 psi,
A water supply line made of ¼ inch (6,4 mm) OD, copper tubing, To determine the length of copper tubing needed, you will need to measure the distance from the ice maker inlet valve at the back of the refrigerator to your cold water pipe, Then add approximately 7 feet (2.1 meters), so the refrigerator can be moved out for cleaning (as shown),
A shutoff valve to connect the water supply line to your household water system. DO NOT use a
A compression nut and ferrule (sleeve) for connecting the water supply line to the ice maker inlet valve.
To Connect Water Supply Line To Ice Maker Inlet Va/ve
|
|
| to Ice Maker |
1, | Disconnect refrigerator from ebctric power source, | _ | F_TubU!_ |
2, | Place end of water supply line into sink or bucket, Turn ON water supply |
| Brass |
| and flush supply line until water is clear. Turn OFF water supply at shut |
| compression |
| off valve. |
| ,Jut |
|
|
|
3.Unscrew plastic cap from water valve inlet and discard cap.
4.Slide brass compression nut, then ferrule (sleeve) onto water supply line, as shown.
5.Push water supply line into water valve inlet as far as it wiii go (¼ inch).
Slide ferrule (sleeve) into valve inlet and finger tighten compression nut | watervalve | |
onto valve. Tighten another half turn with a wrench; DO NOT over tighten. |
| |
6. With steel | clamp and screw, secure water supply line to rear panel of | inbt |
refrigerator | as shown. |
|
7.Coil excess water supply line (about 2V2turns) behind refrigerator as shown and arrange coils so they do not vibrate or wear against any other surface.
8.Turn ON water supply at shutoff valve and tighten any connections that
| leak. |
| flora househald water supply |
9, | Reconnect refrigeratortoelectrical | powersource, | (!ncludeenoughtubinginlooptoallow |
10. | Make sure ice maker power switch | is turned On (See page 14 for location of | rr_ovin_ refr geratorouforcleaning.} |
| power switch), |
|
|
cause !ce make[ to CYC!etwo or three times before making a full tray of ice. New plumbing may cause ice to be discolored or have poor flavor. Discard ice made during the first 24 hours.
