Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
AutoTemp
Med
Hi
Lo
Heat
EnergySaver
Cool
FanOnly
Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
AutoTemp
Med
Hi
Lo
Heat
EnergySaver
Cool
FanOnly
Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
AutoTemp
Med
Hi
Lo
Heat
EnergySaver
Cool
FanOnly
Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
AutoTemp
Med
Hi
Lo
Heat
EnergySaver
Cool
FanOnly
Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
AutoTemp
Med
Hi
Lo
Heat
EnergySaver
Cool
FanOnly
Check
Filter
Sleep
Temp/Timer
Temp/Timer
Remote
Sensing
Timer
Mode
Fan
Speed
AutoTemp
Med
Hi
Lo
Heat
EnergySaver
Cool
FanOnly
LIGHT ON
YOU WILL SEE:
DO THIS:
PRESS
MODE BUTTON
CHOOSE
FAN ONLY
LIGHT ON YOU WILL SEE:
Air Conditioner Features(continued)
TOOPERATEONFANONLY:
Note:Use this function only when cooling is not desired, such as for room air
circulation.You can choose any fan speed you prefer,EXCEPTAUTO FAN.
Duringthis function, the display will show the actual current temperature, not the set temperature as in the cooling mode.
DO THIS:
PRESS
MODEBUTTON
CHOOSE
ENERGYSAVER
LIGHT ON YOU WILL SEE:
TO USE THE
ENERGYSAVER FEATURE:
Note:In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2
minutesat 10 minute intervals until the room temperature is above the set temperature, at which time the unit cooling
systemstarts again.
TIMER-DELAY
START/STOPFEATURE: FIRST
DO THIS:
PRESSTIMER
BUTTON
THEN
DO THIS:
PRESSTEMP/TIMER
BUTTON
Note1: For Delay Stop, the unit must be in the ON position.
Note2: For Delay Start, the unit must be in the OFF position.
Toadjust timer setting, tap or hold the UP arrow( ) or DOWN arrow (v) to change the delay time by .5 hour increments up to
10hours, then by 1 hour increments up to 24 hours. The control will count down the time remaining until start (8, 7.5, 7, etc.).
TheDelay Start mode automatically selects cooling with maximum Fan Speed. The temperature maintained will be the same
as previously set. Tochange the set temperature, press “COOL” then Up or Down arrows until the desired temperature is
indicatedon the display. After 5 seconds, the control will automatically change the display back to the hours remaining until
the unit will start/stop. Turning the unit “ON” or “OFF” at any time will cancel the Delay Start/Stop function. The delay
Start/Stop feature will work until the unit either starts or stops. Once this has happened then the above setps have to be
repeatedagain.
^
7