CareandCleaning
FollowWinterizing (continued)Instructionsforcold weathercare.
WinterizingInstructions
If the washer is stored in an area where freezing can occur or moved in freezing temperatures, follow these winterizing instructions to prevent damage to the washer:
1.Turn off water supply faucets.
2.Disconnect hoses from water supply and drain water from hoses.
3.Plug electrical cord into a properly grounded electrical outlet.
4.Add 1 gallon (3.8 L) nontoxic recreational vehicle (RV) antifreeze to empty wash drum. Close door.
5.Set cycle selector knob at a spin setting. Pull out knob and let washer spin for 1 minute to drain out all water. Not all of the RV antifreeze will be expelled.
6. Push in knob, unplug electrical power cord, dry rum interior, and close door.
7.Remove dispenser drawer. Drain any water in comp rtments and dry compartments. Replace drawer.
8.Store washer in an upright position.
AvoidServiceChecklist | 9. | a complete cycle using detergent. Donotaddwashload. |
| To remove antifreeze from washer after stor ge, run empty washer through |
Before calling for service, review this list. It may save both time and expense. The list includes common concerns that are not
theOCCURRENCEresult of defective workmanship or materialsPOSSIBLECAUSEin this washer. | /SOLUTION |
| ||||
NOISE |
|
|
|
|
| |
|
|
|
| |||
"Clicking"HighRattlingSqealingupitchandsoundnoise"jetclankingengine".orhotnoisenoiserubber..odor. | • A normal sound made by the timer. |
| ||||
|
|
|
|
|
| |
|
|
|
| • A certain amount of motor whine is normal during the spin cycle. |
| |
|
|
|
|
|
| |
Thmping |
| . | • Foreign objects such as coins or safety pins may be in drum or pump. Stop washer |
| ||
| and check drum. If noise continues after washer is restarted, objects may be in |
| ||||
| pump. Call your authorized servicer. |
| ||||
| • Belt buckles and metal fasteners are hitting wash drum. To prevent unnecessary |
| ||||
| noise and damage to drum, fasten fasteners and turn items inside out. |
| ||||
| • Washer is overloaded. Do not overload washer. Stop washer and reduce load. |
| ||||
| • Heavy wash loads may produce a thumping sound. This is usually normal. If sound |
| ||||
Vibrating | noise. |
| continues, washer is probably out of balance. Stop washer and redistribute wash |
| ||
| load. |
|
| |||
|
|
|
| • Washer is not resting firmly on floor. Move washer so it rests firmly on floor. Adjust |
| |
leveling legs. See INSTALLATION INSTRUCTIONS for details.
• Shipping bolts and foam block have not been removed during installation. See INSTALLATION INSTRUCTIONS for removing shipping bolts and foam block.
• Wash load unevenly distributed in drum. Stop washer and rearrange wash load.
11
