103

6

102

iWhen the camera and computer are
exchanging data, the self timer lamp blinks
and the viewfinder lamp blinks alternately
green and orange.
i“ •DSC ” appears on the screen.
iPower Save is disabled when the camera is
connected to a USB port.
✽Before replacing the xD-Picture Card, always
disconnect the camera from the PC using the
procedure on P.104.
✽Do not disconnect the USB cable when the camera is
communicating with the PC. See P.104 for information
on the disconnection procedure.

■PC Operation

✽ The Windows CD-ROM may also be required
during installation. In this event, switch CD-ROMs
as directed by the on-screen instructions.
iFinePixViewer automatically starts up.
Windows 98/98 SE/Me/2000 Professional
iA removable disk icon appears and you can use
your PC to transfer files to and from the camera.
Windows Macintosh
✽Screen for
Windows 98 SE
If the above operations do not occur, you do not have
the required software programs or drivers installed on
your PC. Complete the required PC setup
procedures. Then reconnect the camera to your PC.

■Camera Operation

USE AT DSC MODE
1. The “Found New Hardware” help message
appears in the bottom-right corner of your
screen. This message will close when the
settings are completed. No action is required.
✽This step is not required for subsequent connections.
Windows XP ■When FinePixViewer is not included

in the list of actions to perform

Select “Take no action” and then select the
“Always do the selected action” checkbox. (This
checkbox may not be shown in some cases.)
Click the [OK]button and launch FinePixViewer
manually.
3. A new removable disk icon appears in the
“My Computer” window.
The next time you connect the camera, the removable
disk drive icon and name change to the “FinePix” icon
and name.
TIP
Proceed to “Using FinePixViewer” on
page 106.
2. Specify the settings in the “AutoPlay” dialog
box.

■When FinePixViewer is included in

the list of actions to perform

Select “Viewing images using FinePixViewer”
and then select the “Always do the selected
action” checkbox. (This checkbox may not be
shown in some cases.)
Click the [OK]button to launch FinePixViewer.