Fujitsu C2330 manual Primary Master Submenu of the Main Menu, Auto, Enter

L i f e B o o k C S e r i e s N o t e b o o k B I O S

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies what ATA devices are installed.

*Note that actual hard drive label shown may vary. Depending on the drive type, information such as cylinders, heads and sectors may also be displayed.

PhoenixBIOS Setup Utility

Main

Primary Master [FUJITSU MHT2040AT-(PM)]		Item Specific Help
Type:	[Auto]	Select ATA/ATAPI drive
LBA Format		installed here.
Total Sectors:	78140160
Maximum Capacity:	40008MB	[Auto]
		The BIOS auto-types the
Multi-Sector Transfers:	[16 Sectors]	drive on boot time.
LBA Mode Control:	[Enabled]
PIO Transfer Mode:	[Multiword DMA 2]	Except [Auto]
DMA Transfer Mode:	[Disabled]	You enter parameters of
		the drive.
		[None]
		The drive is disabled.

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 2. Primary Master Submenu

Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu

Menu Field	Options	Default	Description
Type:	• Auto	[Auto]	Selects the ATA/ATAPI device type. Select Auto to have the type
	• None		automatically identified by the BIOS at POST. If None is selected, all
	• CD-ROM		of the following Set-up items do not appear. Select CD-ROM if a
	• Hard Disk		CD-ROM drive is installed at this connection. If Hard Disk is
			selected, you must specify the number of Cylinders, Heads, and Sec-
			tors for the drive.
CHS Format (Cylinders, Heads, Sectors)
Cylinders:	• A number	–—	This appears only when Hard Disk is selected. When Hard Disk is
	between 0 and		selected, you can change the value. This field is incremented by
	65,535		pressing the [Spacebar]). This field is decremented by pressing the [-
			] key. You can also change the field by typing in the number.
Heads:	• A number	–—	This appears only when Hard Disk is selected. When it is selected,
	between		you can change the value. This field is incremented by pressing the
	1 and 16		[Spacebar]). This field is decremented by pressing the [-] key. The
			field can also be changed by typing in the number.

6