Features
Default Settings in the menu Configure/View SCSI Controller Settings
SCSI Bus Interface Definitions | Default setting |
SCSI Controller ID | 7 |
SCSI Controller Parity | Enabled |
SCSI Controller Termination | Enabled |
Additional Options | Default setting |
Boot Device Configuration | Press <Enter> |
Single Image |
|
Master SCSI Controller | |
Select SCSI peripheral from which to boot |
|
Boot SCSI Controller | |
Boot SCSI ID | 0 |
Boot LUN number* | 0 |
SCSI Device Configuration | Press <Enter> |
Sync Transfer Rate (MB/Sec) | 320 |
Packetized | Yes |
QAS | Yes |
Initiate wide negotiation | Yes (Enabled) |
Enable disconnection | Yes (Enabled) |
Send Start Unit Command**** | Yes |
BIOS Multiple LUN Support | No |
Include in BIOS Scan | Yes |
Advanced Configuration | Press <Enter> |
Reset SCSI Bus at IC Initialization | Enabled |
Display <Ctrl><A> Message During BIOS Initialization | Enabled |
Extended Int 13 Translation for DOS Drives > 1Gbyte | Enabled |
POST Display Mode | Verbose |
SCSI Controller Int 13 Support | Enabled |
Domain Validation**** | Enabled |
Support Removable Disks Under Int 13as Fixed Disks**** | Disabled |
BIOS Support for Bootable | Enabled |
*The setting is valid only if Multiple LUN Support is enabled.
****The setting is valid only if the Int 13 Support of the SCSI controller is enabled (Enabled).
English - 11 |
