S T E P Monitoring Setup

Perform the ETERNUS DX60/DX80 monitoring setup if required.

n Notification of ETERNUS DX60/DX80 problems as they occur is possible if the event notification method and level have been set.

n For e-mail notification of ETERNUS DX60/DX80 problems, a destination e-mail address must be set.

nIf "ServerView" is used to monitor the server, the ETERNUS DX60/DX80 must be set to send an SNMP Trap to the server.

nIf remote support is required, the ETERNUS DX60/DX80 must be set to notify the remote support center of failures.

Point

Remote support allows prompt detection and resolution of trouble.

 

 

"7.4 Monitoring Setup" in the "User Guide"

S T E P Server Connection

Various tasks need to be performed before the ETERNUS DX60/DX80 can be connected to the server. These include the installation of the appropriate drivers.

Check which server OS, and/or SAS card are to be connected to before starting this step.

For details on the setting, refer to "ETERNUS DX Disk storage systems Server Connection Guide (SAS)"(*).

* : Download from the specified web-site in the Documentation CD.

n"7.5 Server Connection Setup" in the "User Guide"

n"ETERNUS DX Disk storage systems Server Connection Guide (SAS)"

- for Windows®

- for Linux

- for Solaris™ Operating System

- ETERNUS DX Disk Storage System Settings for ETERNUS DX60/DX80

- for VMware® ESX

 

All necessary settings are complete, and the ETERNUS DX60/DX80 is now ready for normal operation.

S T E P Operation and Maintenance

Status check

The status of the ETERNUS DX60/DX80 should be regularly monitored by checking the LEDs and using the Web browser.

Data backup

Important data should be regularly backed up to a tape drive or similar device as a precaution against system failures.

Maintenance support period

The maintenance support period for the ETERNUS DX60/DX80 is 5 years from the date of purchase.

This manual uses recycled paper.

ETERNUS DX60/DX80 Disk storage system Setup Guide

(SAS model)

P3AM-3102-04EN

Date of issuance: July 2010

Issuance responsibility: FUJITSU LIMITED

Printed in Japan

The contents of this manual may be updated without notice.

While the contents of this manual are the product of all due care and diligence, no responsibility can be accepted for operational problems arising from any errors or missing information, or other use of the information contained in this manual.

Fujitsu assumes no liability for damages to third party copyrights or other rights arising from the use of any information in this manual.

Contents of this manual are not to be reproduced without permission from Fujitsu.

Manuals with missing or wrongly collated pages will be replaced free of charge.

Page 4
Image 4
Fujitsu DX60, DX80 setup guide E P Monitoring Setup, E P Server Connection, E P Operation and Maintenance