Fujitsu E8410 manual Fir

L i f e B o o k E S e r i e s B I O S

Serial/Parallel Port Configuration Submenu of the Advanced Menu

The Serial/Parallel Port Configuration submenu lets you set the I/O addresses and interrupt levels for the serial, infrared and parallel ports of your notebook.

I/O addresses, DMA channels and Interrupt levels can be entered in various ways, including via the BIOS setup utility, the control software for the I/O device, or the hardware. If any two ports or devices, serial or parallel, have the same address assigned, your notebook will not function normally. Keep a record of original settings before making any changes if restoration is required. See your hardware and software documentation as well as the setup utility to determine settings and limitations.

■To prevent IRQ and address conflicts, avoid changing the default settings. If you must change the settings, you can call 1-800-8Fujitsu for technical assis- tance.

■If your notebook emits a series of beeps that sounds like a code and the display is blank, refer to the Troubleshooting Sec- tion in the system User’s Guide. The Troubleshooting Section includes a list of error messages and their meanings.

■All I/O addresses in Table 6 are in hexa- decimal.

		Phoenix TrustedCore(tm) Setup Utility
Info	System	Advanced	Security	Boot	Exit
	Serial/Parallel Port Configurations				Item Specific Help
Serial port:			[Enabled]		[Disabled]
					The port is disabled.
Base I/O Address/IRQ:			[3F8/IRQ 4]
Infrared Port:			[Enabled]		[Enabled]
Mode:			[FIR]
					The port is enabled
Base I/O Address/IRQ:			[2E8/IRQ 3]
					with user configuration.
DMA Channel:			[DMA 3]
Parallel Port:			[Enabled]		[Auto]
Mode:			[Bi-directional]
					Plug & Play OS
Base I/O Address:			[378]
					configure the port.
Interrupt:			[IRQ 7]

F1 Help	Select	Item
ESC Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 6. Serial/Parallel Port Configuration Submenu

12