58_0497_02.fm Page 2 Tuesday, July 10, 2001 2:18 PM
ASSEMBLING THE ANTENNA COVER KIT
Note: This section is applicable only to antenna cover model FMW42RC1 only; the FMW42CR2 model is
The radio antenna cover kit consists of the following parts:
■Plastic Hood
■Plastic Base
■ Two screws (M2.5 x 8 mm long, finish:black zinc)
■One tapping screw (Model FMW42RC1 only)
To assemble the radio antenna cover, place the hood atop the base as illustrated in Figure 1. Make sure the positioning tab is on the inside of the hood. Secure the two pieces with the tapping screw by inserting it through the hole in the base into the standoff inside the hood.
Hood
Standoff 
Positioning
Tab (inside)
Base | Tapping Screw |
|
Figure 1. Assembling the Radio Antenna Cover
2
