93
- Memory Upgrade Module
Removing a Memory Upgrade Module
1Perform steps 1 through 4 of Installing a Memory Upgrade Module.
2Pull the clips sideways away from each side of the memory upgrade module at the same time.
3While holding the clips out, remove the module by lifting it up and pulling it away from your Tablet PC.
4Store the memory upgrade module in a static guarded sleeve.
Replace the cover and reinstall the screws.
Checking the Memory Capacity
Once you have changed the system memory capacity by replacing the installed module with a larger one,
be sure to check that your Tablet PC has recognized the change.
•If you are in Control Panel Category view, check the memory capacity by clicking [Start] -> Control
Panel -> System and Security -> System -> View amount of RAM and processor speed. The
amount of memory is displayed next to “Memory - RAM:”
•If you are in one of the icon views, check the memory capacity by clicking [Start] -> Control Panel
-> System. The amount of memory is displayed next to “Memory - RAM:”
There may be a variation between the actual memory size and what is displayed. This is possible if your
system is configured with an integrated Intel Graphics Media Accelerator which dynamically allocates
system memory to accelerate graphics performance.
IF THE TOTAL MEMORY DISPLAYED IS INCORRECT, CHECK THAT YOUR MEMORY UPGRADE MODULE IS
PROPERLY INSTALLED. (IF THE MODULE IS PROPERLY INSTALLED AND THE CAPACITY IS STILL NOT
CORRECTLY RECOGNIZED, SEE TROUBLESHOOTING ON PAGE 105.
Curlin_WWAN-B6FJ-5051-02ENZ)-00.book Page 93 Tuesday, October 19, 2010 1:57 PM