Fujitsu MHS2020AT, MHS2030AT, MHS2040AT Spare Parts, Disk Drive Removal, 1 Model and parts numbers

2.1 Spare Parts Removal and Replacement Procedure

2.1Spare Parts

See Table 2.1 for the model and parts numbers to order the replacement disk drive.

Table 2.1 Model and parts numbers

Model	Part number	Formatted	Mounting screw
		capacity
MHS2060AT	CA06272-B042	60 GB
MHS2040AT	CA06272-	40 GB
	B83100DX		M3 (depth 3)
MHS2030AT	CA06272-B022	30 GB
MHS2020AT	CA06272-	20 GB
	B82200DY

2.2Disk Drive Removal

The method and procedures to demount the disk drive to check the jumper terminal, change the jumper position, or replace the device differ depend on the system cabinet structure. Therefore, for actual working procedures, the specific conditions necessary for each system must be determined. The general removal procedures, with notes, is as follows.

a)Disconnect the power-interface cable.

b)Remove the screws that attach the drive and remove the drive from the system cabinet.

c)When storing or transporting the drive, pack it an antistatic bag.

To protect the device from damage and prevent the worker getting hurt, observe the following cautions and precautions in Subsection 1.1.1.

Damage or Device damage

1.Perform any removal after the system power is completely disconnected. The cable must not be disconnected and the screws that attach the drive must not be removed with the power ON.

2.Do not move the drive until it comes to a complete stop (about 30 s after the power is turned OFF).

3.Perform the human body grounding to discharge any static electricity from your body. (Be sure to wear a wrist strap)

2-2 C141-F059-01EN